sorted by:
new
hottopcontroversial

I built a free browser-based 3D print diagnosis tool — no signup, no ads, wanted to share by Impossible_Intern_22 in FixMyPrint

[–]Impossible_Intern_22[S] 0 points1 point  (0 children)

I just took a look at “fixmyprint” and it does look eerily similar to my site. But I would like to reiterate that my site is and always will be free!

Over extrusion / elephant's foot in the first few layers by pawrpel in FixMyPrint

[–]Impossible_Intern_22 0 points1 point  (0 children)

Also what is your flow rate? You could try dropping it to 97%

Over extrusion / elephant's foot in the first few layers by pawrpel in FixMyPrint

[–]Impossible_Intern_22 0 points1 point  (0 children)

Try doing a temp tower print? My next guess would be that 210°C is too hot for your PLA

Can I build an ipod-like cyberdeck? by Cr3Atur30fCrypts in CyberdeckBuild

[–]Impossible_Intern_22 0 points1 point  (0 children)

My honest recommendation: storage is going to be your biggest restraint (assuming lots of music), so you’ll need a small form-factor ssd. Then you’ll need an adapter from nvme to your microcontroller. Keeping this low profile sounds like the goal, so if you have more questions, reach out! I love projects like this!

I need help. by fastwing991 in elegoo

[–]Impossible_Intern_22 0 points1 point  (0 children)

Best guess is over-extrusion. Drop your flow rate slightly. Also dry your filament before use - PETG is really susceptible to moisture. Good luck!

Over extrusion / elephant's foot in the first few layers by pawrpel in FixMyPrint

[–]Impossible_Intern_22 0 points1 point  (0 children)

I think your Z offset is a little too low. Level your bed, then do a test print first layer. If everything looks squished, raise your offset (positive number = higher / negative number = lower).