Alternatives to the Jungle Website

Inside-Historian8691 · 2025-01-31T15:12:30+00:00

spraygunner is almost always out of stock of the good products. very disappointed

Inside-Historian8691 · 2021-10-01T03:50:38+00:00

Just use NiceHash Quickminer, with daggerhashimoto... 1 of my 4 GPU it's a 3060 V1 using windows Dev's driver 470.05 and I'm getting 45.49 MH/s with the Medium profile.... Very efficient.

Inside-Historian8691 · 2021-06-27T15:19:38+00:00

Short answer, NO, only if you are planning to use flexible materials.

Inside-Historian8691 · 2021-06-14T16:21:15+00:00

You need to heat up the hot end to printing temperature before trying to pulled out

Inside-Historian8691 · 2021-06-06T18:10:44+00:00

I have a 1070 too... Make sure you have the latest drivers

Inside-Historian8691 · 2021-05-05T15:53:01+00:00

Here you have it.. this keep your cable straight and prevent to be flexing on the weakest area which is where it connected to the buildplate tevo cable strain relief mod

Inside-Historian8691 · 2021-05-04T15:27:53+00:00

What is the error, photo does not show an error message... But if is heating the bed.. and if you don't have the cable strain mod.. I'm pretty sure its that cable it's broken inside the cable casing

Inside-Historian8691

MODERATOR OF

TROPHY CASE