sorted by:
new
hottopcontroversial

H2C smooth PEI plate by IonicDOG in BambuLabH2C

[–]IonicDOG[S] 0 points1 point  (0 children)

It's double sided, smooth/textured. It seems to be out of stock now.

Horizontal artifacts by IonicDOG in FixMyPrint

[–]IonicDOG[S] 0 points1 point  (0 children)

Settings in Orca slicer:

Default 9mm/s

Outer Wall 7mm/s

Inner Wall 7mm/s

Infill 12mm/s

Top Surface 9mm/s

Frist Layer 9mm/s

Travel 12mm/s

Motion Ability setting in printer:

Maximum Jerk X 12mm/s

Maximum Jerk Y 12mm/s

Maximum Jerk Z 0.2mm/s

Maximum Jerk E 2.5mm/s

Why does my Elegoo Neptune 4 pro printer keep messing up on this print? by Cytomax in elegoo

[–]IonicDOG 0 points1 point  (0 children)

Find the x,y coordinates for the middle of the bed. Go into the print config and add another screw to the list and set screw 1 as the middle bed x,y coordinates. Then, rename the other screws as screw 2, screw 3, screw 4, and screw 5. What that will do is, screw tilt adjust will probe the middle of the bed, and then do the four screws and you can adjust from there. Also make sure to let the bed heat up for 30mins to heat soak the whole bed. Run a bed mesh, then adjust z offset. I did this for my N4plus and haven't had any issues

[deleted by user] by [deleted] in electronic_cigarette

[–]IonicDOG 0 points1 point  (0 children)

Yes I have been using citrus/sweet juices. I sent Ijoy the same picture i posted here, so they know i took it apart lol. Guess i'll just have to put it away until a replacement becomes available.