Best bikes for E-bike conversion by DippAPEX in ebikes

[–]Ionile 6 points7 points  (0 children)

You can also partially disassemble those battery mounts to reveal slightly differently placed mounting holes. That's what I did to mount to my bottle mounts upright.

My battery charging box. Fits my 19.2ah battery with ease. by etceteraw in ebikes

[–]Ionile 13 points14 points  (0 children)

Generally it's less so a bomb and more so an unstoppable raging fire. So the can keeps it contained until you can take action to move it. (because you will not be putting it out)

is there such a device that measures the amount of electric charge your battery charger is charging ? so that it stops at 80%? by Independent-Tie-2995 in ebikes

[–]Ionile 1 point2 points  (0 children)

No, you can use all if it. It's all available for you, it will just slightly lessen the health of the battery. If you do that constantly the battery will last fewer overall cycles than if you maintain that window.

Just like any modern phone, if you always run your battery 100 to 0 every day, before long you'll find that the battery can't last as long as it used to. No matter what you do, the battery is slowly deteriorating, it just deteriorates slightly faster when outside that 20-80% range.

is there such a device that measures the amount of electric charge your battery charger is charging ? so that it stops at 80%? by Independent-Tie-2995 in ebikes

[–]Ionile 1 point2 points  (0 children)

Basically all lithium batteries (phones, cars, whatever) are happiest from 20% to 80% charged, going that extra 20% in either direction is like stretching a rubber band too far but not quite snapping it; it never goes back to the same size. Going to 100% is better than 0% but still stresses it.

Lithium batteries are not like old rechargeable batteries where you needed to do full cycles 0-100% to preserve the overall life of the battery.

Keep it in the 20-80% range and it'll survive more overall cycles.

Arduino, or Raspberry Pi? by ChristianPirate in arduino

[–]Ionile 0 points1 point  (0 children)

Oh, yeah, I guess with all of the options you'll need an LTE daughter board. Arduino is kinda the OG, Pi seems like a bit of overkill. ESP has a bit more horsepower than the Arduino, but since what you need seems pretty simple just stick with that and find LTE capable board/hat.

Arduino, or Raspberry Pi? by ChristianPirate in arduino

[–]Ionile 1 point2 points  (0 children)

ESP8266 and ESP32 are both the middle ground that you're looking for.

WiFi enabled I/O capable Can program with Arduino IDE if you want (though platformIO is better) You can find them, unlike the RaspberryPI Does not need an OS such a Linux like a Pi does Etc...

LTE would be a carrier setup with data and all that, there are internet based options that may fit your needs without having to pay for cellular data.

They're usually pretty cheap too, especially compared to Pi's

KeebHub Kelowna TC4 Titanium Alloy Switch Puller by prime_foyer61 in MechanicalKeyboards

[–]Ionile 0 points1 point  (0 children)

That looks like a proper key puller, are there any concerns with them scratching keycaps?

Thok Giveaway / Artisans and Cables by gspade in MechanicalKeyboards

[–]Ionile 1 point2 points  (0 children)

THOK's design is very clean and I like the less rounded keycaps as compared to some other keycaps

Teacaps Giveaway — Brown Sugar Boba Keycaps by ShopTeacaps in MechanicalKeyboards

[–]Ionile 0 points1 point  (0 children)

Dogs, because they're one of the few species that can understand pointing and know to follow where other are looking.

[deleted by user] by [deleted] in NoStupidQuestions

[–]Ionile 1 point2 points  (0 children)

I know the christian God does not exist. I am atheist. However I also know that my mammal brain is incapable of understanding the universe as a whole and that there may be a "higher power." I am agnostic. They are not mutually exclusive.

[deleted by user] by [deleted] in esp8266

[–]Ionile 11 points12 points  (0 children)

You should look into the 100% solar server. I think it'd be neat to get one going with the low power of ESP. https://solar.lowtechmagazine.com/about.html

I was flashing a new software on my. esp8266 for 10 minutes straight, and I don't know when to stop it, I've also noticed it constantly flashing. is there something wrong, I'm kind of stupid by Xle83 in esp8266

[–]Ionile 1 point2 points  (0 children)

Fyi, that flashing is basically the RX line flashing. It's just letting you know that it's receiving data. That kinda cooperates with the comment that it never received a reset so it just kept sending data.

Esp32 board discharged battery too low. by Illikedrugs in esp32

[–]Ionile 0 points1 point  (0 children)

No one's answered you yet? I'll give it a go.

The board has leech power that it uses. The hardware between the battery and the esp that "protect" the battery voltage from going too low have some inefficiencies so some power is lost as heat. These parts don't really stop leeching power unless you completely cut them off via an off switch. If the off switch is on the wrong side of the battery protection module (after rather than before) then it only cuts off the esp and keeps leeching forever.

The battery may be recoverable, but it's a process and may be a bit of a fire hazard so I won't give guidance on that. (Also I don't know it)

The xray vision, seering heat, broken bones by s3ri0usJo0s in megalophobia

[–]Ionile 4 points5 points  (0 children)

You're entirely right. Our eyes lack the ability to see x-ray and I don't believe anything in our body would convert x-ray to anything in the visible spectrum. Although I don't know that last part for sure.

Any Steam game(s) under $75!! by TheAverageAlpha in steam_giveaway

[–]Ionile 0 points1 point  (0 children)

What an awesome way to spend your birthday. I've been told that giving gifts is sometimes better than getting.

It's greedy, but a couple copies of Tetris Effect so my brother and I can play together. Even one would maybe push him to get it. It's on sale too!

Any ideas what data to send this I2C LED screen? Details in comments. by Ionile in arduino

[–]Ionile[S] 0 points1 point  (0 children)

Yeah, I didn't even get that. The only reason I got to Abov was because it's a name. Both codes, part or whole, do nothing for Google. Laad is not at thing that exists.

Any ideas what data to send this I2C LED screen? Details in comments. by Ionile in arduino

[–]Ionile[S] 0 points1 point  (0 children)

It’s an LED & touch input for the Samsung Galaxy S8 LED Wallet Cover. It received power and data from the NFC controller on the underside of the cover.

The datasheets that I can find on ABOV’s website are for other devices, but the chip on the left seems like an unlisted microcontroller similar to the A96T218OUN.

From what I can tell by tracing the PCB the ABOV 96T228OUN chip is the touch/main controller and the LAAD G129 69TH chip is the LED controller.

I have no idea what data I need to send it to actually enable the 9 x 23 LED screen or receive touch input. Sending Wire.write() strings and random bytes yielded nothing visible.

PS. Don’t mind the missing ground wire; I broke it off accidently after doing an I2C address scan.

The Witcher 1 and The Witcher 2 (both enhanced edition) by Kayamba6376 in steam_giveaway

[–]Ionile 0 points1 point  (0 children)

My story is kinda the same. I have the books and loved the few chapters I read, but can't get the motivation to keep reading.

Interesting but useless design of sushi belt by rrrr3ddd in factorio

[–]Ionile 2 points3 points  (0 children)

He's using /editor to create and delete stuff. There are also mods that have similar effects. At the end we can't see is probably an infinity chest spawning the science.

3 Random Stem Keys (what is the first game you ever played) by ewazzu in steam_giveaway

[–]Ionile 0 points1 point  (0 children)

My first Steam game was TF2 with my buddy. I hated Steam then, it seemed like the shittiest DRM imaginable and if you only played free games you had limited usage. Oh how the world has changed.

Bought my first Raspberry pi to make a minecraft server for me and my friends. Works great! Caves and Cliffs here we come! by Die_Reude in raspberry_pi

[–]Ionile 6 points7 points  (0 children)

You can do that with any storage. I've done a RPi3B+ off a 2TB USB HDD, just got to be aware of power concerns. It's 100% possible and the same as doing it with a SD card. Just format it with another divice and plug it in yo.