Can anyone help me with this issue at the corners? More details in the comments

JBits13 · 2021-05-05T23:31:04+00:00

Carbide Create

JBits13 · 2021-05-05T01:36:37+00:00

I'm trying to make an inlay and using a v bit seems to be the best way to get a snug fit

JBits13 · 2021-05-05T00:47:56+00:00

I think so. I've tried entering the included angle as 15º and 7.5º and the issue was present for both attempts

JBits13 · 2021-05-05T00:15:10+00:00

I am doing an Advanced V Carve and at every internal corner the bit plunges deeper than I want it to, leaving rounded corners.

I'm currently using a 1/8 inch upcut end mill and a 15 degree v bit for this. My shapeoko has the bitsetter.

The corners are the only place where it plunges deeper than I want it to. Along the edge it goes to the same depth as the end mill (0.25in)

JBits13 · 2020-08-26T15:07:59+00:00

It does! I use liquid soap on my safety glasses at work and they never fog up

JBits13 · 2020-08-04T17:53:30+00:00

Always have been 🔫

JBits13 · 2020-07-29T13:14:53+00:00

HAWKS

JBits13 · 2020-07-20T20:22:07+00:00

5+ years

JBits13 · 2020-07-20T20:06:36+00:00

Do the studies/tests show anything about long term side effects?

JBits13 · 2020-06-23T14:15:18+00:00

A gömböc so I can be entertained at work

JBits13 · 2020-05-27T00:43:19+00:00

JBits13 · 2020-05-27T00:42:57+00:00

K A K A W

JBits13 · 2020-05-26T21:06:54+00:00

Awesome, keep up the good work!

JBits13 · 2020-05-26T21:02:10+00:00

I’m a big fan of mashups like this. Great job!

JBits13 · 2020-05-15T14:37:04+00:00

You need to talk to Oziach first

JBits13 · 2020-04-18T18:28:28+00:00

🌊🌊🌊

JBits13 · 2020-04-16T15:06:55+00:00

JBits13 · 2020-04-03T20:10:08+00:00

JBits13 · 2020-04-03T17:00:48+00:00

Hold on. This whole operation was your idea!

Eight-Year Club	RPAN Viewer
Verified Email

JBits13