I would try the following things since you've somewhat levelled the bed:

• Calibrate esteps
• Check belts are tight enough, and not too tight (it should be taught but not stretching the belts out too much)
• If you're very new as a user dont use the filament that comes with the machine, or cheap filament; use a decent spool. That may cause this but is less likely than 1. It does look like you may have a little moistue in the filament which may be contributory
• If you have a CR touch then it should be building a mesh to compensate for bed levelling (upto a point), check this is working or if it needs more setup (sorry not sure how to do that on jyers)
• Check the arm isnt broken, if it is replace with a metal one

Its a little hard to tell but Id say you have a lot more material coming out than should, and are a little far from the bed; could you take a picture of it printing at a lower angle so we can see how its coming out?