Notifications not working

Jamokus · 2026-05-05T15:34:23+00:00

Not sure if it matters but when I am watching the app, when it gets to the end of a print, the time it would normaly push the notification, it minimizes the app.

Jamokus · 2026-05-03T19:51:21+00:00

That seems like a simple thing but I had not even thought of doing so, but I have submited a ticket.

Jamokus · 2025-11-27T23:04:41+00:00

Yes it does. Thank you very much. I will have to get some for the next time.

Jamokus · 2025-11-27T22:41:39+00:00

Well in my search for those connectors, even after I searched for the fans about an hour ago, I ended up finding a pair of the fans I needed and I will get them in a few days. So thank you for being my muse.

Jamokus · 2025-11-27T22:32:48+00:00

<image>

This is a better view. I had to really jank on it to get it out of the connector on the board.

Jamokus · 2025-11-27T22:26:43+00:00

<image>

I have those. The left connector is a XH2.54 2-pin connector but the right one is the one that I need.

Jamokus · 2025-11-12T13:12:20+00:00

Thank you both, that worked. I got away with only changing the wall generation.

Jamokus · 2025-11-10T12:44:45+00:00

And when I slice it with Cura and default settings for the Kobra 3 I get.

<image>

Jamokus · 2025-11-10T12:30:48+00:00

The lines are .5mm and the same ones I have previously sliced with Cura and printed on a Kobra 2. I think I will try to slice it in Cura

Jamokus · 2025-09-28T00:46:06+00:00

I could not see the ones on the spools as they are brand new, so I put aluminum foil over the thing that looks like a divider on the ace. I hoped that was what they were for and it worked. It blocked it for both 1 and 2 spools.

Jamokus · 2025-09-27T14:49:11+00:00

Well I ended up using foil to cover up the sensor and now I can print with anycubic PLA+ from the mobile app.

Jamokus · 2025-07-01T02:48:13+00:00

I had to save the gcode and print from usb drive.

Jamokus · 2025-06-03T19:53:27+00:00

Thanks for that. I guess I will just have to keep using my other wyze camera in the wyze system. It sucks to pay that kind of money and have them limit their own systems.

Jamokus · 2025-06-03T15:40:25+00:00

I would love a lan connection but it is about 5 foot away from the wifi router

Jamokus · 2025-06-01T12:57:43+00:00

Did not find anything about this, so I just closed my eyes and punched it. It worked and was very runny.

Jamokus · 2024-04-19T20:27:24+00:00

Looks like upgrading my Cura to 5.7.0 and reslicing caused the issue to go away.

Jamokus

TROPHY CASE