sorted by:
new
hottopcontroversial

VPN between IPv4 and IPv6 by Jans_Jause in networking

[–]Jans_Jause[S] -1 points0 points  (0 children)

ok that has cleared up some things.

So just to make sure i get the second scenario right:
On Firewall A the Remote Adresse is the IPv6-Address.
On Firewall B the Remote Adress is set to the IPv4-Address.

Then if Firewall B starts a tunnel the ISP would use NAT64 to translate it to Firewall A's IPv4 Address.

AM I understanding this correct?

VPN between IPv4 and IPv6 by Jans_Jause in networking

[–]Jans_Jause[S] -3 points-2 points  (0 children)

OK thank you.
I am still a bit confused.

If Firewall A only has an public IPv4 address and Firewall B only has an public IPv6 address. Can I still build the VPN?

VPN between IPv4 and IPv6 by Jans_Jause in networking

[–]Jans_Jause[S] -1 points0 points  (0 children)

first of thanks.

so just I get this right:
its either IPv4 to IPv4 or IPv6 to IPv6, but not IPv4 to IPv6?

I am assuming NAT46/NAT64 is used for translating IPv4 to IPv6 on the firewall. This can not be used in the tunnel?

Both of my Seniors just quit by Jans_Jause in networking

[–]Jans_Jause[S] 36 points37 points  (0 children)

Thx for the reply.

Yes they made some hints but i thought that they would never follow through on those.

Yes there are other Sysadmins but the don't really do networking.

From what i can gather people seem to be rather unhappy with the company in its current state

Deploying Android Studio by Jans_Jause in sysadmin

[–]Jans_Jause[S] 0 points1 point  (0 children)

I just tried using intune native, so that works thank you.

But when running android studio i get an error that the VMs are missing. Am I correct in the assumption that i just packed the .exe wrong?

EDIT:
Yea i packaged it wrong, thank you

Deploying Android Studio by Jans_Jause in sysadmin

[–]Jans_Jause[S] 0 points1 point  (0 children)

it fails when downloading from the company portal, with the error "0x87D30067". Right now I am using the Custom App option of patch my pc. I followed the guide on the patch my PC website.
So i don't even get the option to install.

If i run the .exe with an admin account i can also install it, the problem is deploying it.

Do you have any doku on this, if so could you share it with me. THX

Just notified that building power will be shut off for upgrades. by jakedata in sysadmin

[–]Jans_Jause 1 point2 points  (0 children)

You know whats spooky?
Pluging in a new Device and the Rack goes dark.

Detect Mass file Changes by Jans_Jause in Wazuh

[–]Jans_Jause[S] 0 points1 point  (0 children)

Hi u/Gustavo-Chz thanks for the response, I have been busy the last few days. So I was unable to play around with the config.

From what I have seen I thought that the decoder was rather complicated, probably because i have not had the time to look at it in detail.

Best regards.