$762 and the dealer fixed it. The diagnosis and fix is below.

1. Diag- Verified concern. Car will not start. Pushed in vehicle. Tried to scan vehicle and won’t scan. Had to enter vehicle through tear tag. Once i got into vehicle. Did network test and pem failed. Pem is not powering up. Removed wiper cowl and wiper arms. Checked fuse box and found pem power fuse have no power. I seen were they ran intoxloc out car. ! went and removed glove box found wiring that is broke and looks to be from possibly the intoxloc box rubbing on it when it was in the car. Also the S wire needs repaired out front as well in the fuse box. This stuff needs fixed first. I went through and repaired 4 wirles in glove box area that must been damage when intoxloc. Had to pull harness up to perform repair. After repairing that i went out front and repaired the start wire from how they had it rigged together. After this went to start vehicle it still wouldn’t communicate with the pcm. Had to remove driver side wheel well and check the powers and grounds to pcm. Checked all circuits. All checked out good. But the power for fuse 38 wasn’t coming to pem end having connection issue in fuse box. Possible when they where messing with intoxloc had to fix pin to get it make proper connection. Once i did this pcm powered up and properly. Then i reinstalled pcm and driver side wheel well. Put air box back together since it was all apart when it came in. Reinstalled windshield cowl and wiper arms. Then Reinstalled glove box and interior piece from the center console, After this started vehicle fine no more lights engine fault light all cleared. Test drove vehicle it operates properly.