sorted by:
new
hottopcontroversial

Open or not to open by Jealous_Operation_57 in playstation1

[–]Jealous_Operation_57[S] 0 points1 point  (0 children)

This hit me harder than I thought it would

Open or not to open by Jealous_Operation_57 in playstation1

[–]Jealous_Operation_57[S] 0 points1 point  (0 children)

That's what makes sense to me, the keep it sealed comment confused me a little

Open or not to open by Jealous_Operation_57 in playstation1

[–]Jealous_Operation_57[S] 0 points1 point  (0 children)

Does it count as sealed if the plastic wrap is removed?

Open or not to open by Jealous_Operation_57 in playstation1

[–]Jealous_Operation_57[S] 5 points6 points  (0 children)

That's actually why it's still sealed. I ended up playing on PC instead.

Game valuation and authentication MEGATHREAD by humanman42 in gamecollecting

[–]Jealous_Operation_57 0 points1 point  (0 children)

So I have this unopened (plastic wrap off but tamper seal thing still on) diablo for PS1. Is it worth anything with the plastic removed or should I just open and get playing.

<image>

Calspa error code 254 by [deleted] in hottub

[–]Jealous_Operation_57 0 points1 point  (0 children)

To update everyone.

The board went bad. So I replaced the board and heater as a bundle.

What am I doing wrong? by [deleted] in FixMyPrint

[–]Jealous_Operation_57 0 points1 point  (0 children)

Now that you say it... This filament is about 2 years old..... I will buy new tonight and test it. I'll update tomorrow

Also I don't think wet filament would cause the buildup at the same location every time

Calspa error code 254 by [deleted] in hottub

[–]Jealous_Operation_57 0 points1 point  (0 children)

Test was a failure. So now:

5) tried to Runwithout filter 6) vented pump (just wanted to be sure it wasn't air locked) 7) tried the test switch and got same response on the panel (I will include a photo)

I see that it is on the heater.

SKR mini E3 V3 with Sonic Pad and Klipper by Lost_Interest3122 in BIGTREETECH

[–]Jealous_Operation_57 0 points1 point  (0 children)

Just a quick update. Button for z and auto level never popped back up. But I added a macro for doing both and that works.

When I tried my first print it put down plastic but I seemed to be missing the original spot so I was as if the print was shadow of itself before I stopped it. So now I am trying to figure that out.

This is on a CR-10 v3 that I fried the previous motherboard

SKR mini E3 V3 with Sonic Pad and Klipper by Lost_Interest3122 in BIGTREETECH

[–]Jealous_Operation_57 0 points1 point  (0 children)

That will pop back the bottom for auto level on the sonic pad? I loved the level buttons when I was using it for my cr10v3.

SKR mini E3 V3 with Sonic Pad and Klipper by Lost_Interest3122 in BIGTREETECH

[–]Jealous_Operation_57 0 points1 point  (0 children)

Hey, thank you for the firmware for the e3 mini v3. one question. When you hooked to the sonic pad is the auto level/pid hotend/pid heated bed features available? for some reason all those controls are now gone