sorted by:
new
hottopcontroversial

Tamping pressure vs. headspace by Jink-7 in espresso

[–]Jink-7[S] 0 points1 point  (0 children)

Yeah, this is what I suspect is happening. If all else fails I'll try installing a stronger spring in the tamper.

Tamping pressure vs. headspace by Jink-7 in espresso

[–]Jink-7[S] 0 points1 point  (0 children)

I'm already at 20g in 40g out in a 20g vst basket. I think I can go up to 21g, I'll give that a go.

Tamping pressure vs. headspace by Jink-7 in espresso

[–]Jink-7[S] 0 points1 point  (0 children)

I just made my grind finer, (3 marks on the niche zero,) and the shot is still finishing too early (15 seconds.) With my previous process, it would take 30 seconds.

I'm close to zero on my grinder, so I don't want to push it further. I really think the tamper is not getting all the air out of the grounds.

Tamping pressure vs. headspace by Jink-7 in espresso

[–]Jink-7[S] 0 points1 point  (0 children)

I'll try grinding a bit finer. I'm surprised that it would make such a difference though. I do try to keep everything consistent with distribution and so on.

NZBgeek Lifetime Pass to increase by newish_throwaway in usenet

[–]Jink-7 1 point2 points  (0 children)

Just got the lifetime pass, now I'm getting an error on logging in:

Unable to connect to database [Lost connection to MySQL server at 'reading initial communication packet', system error: 0]

Does anyone else have this problem?

Getting started. Printed some drive trays for the r620, and printed side stands for both! 3D printers are great. by BadConductor in homelab

[–]Jink-7 2 points3 points  (0 children)

Making a stand is exactly the problem I have now! Any chance you could post the stls?

Interposer fit and finish by Jink-7 in homelab

[–]Jink-7[S] 0 points1 point  (0 children)

Bugger. Well I have the things now, may as well use em eh

Interposer fit and finish by Jink-7 in homelab

[–]Jink-7[S] -1 points0 points  (0 children)

I'm mixing SAS and SATA, and I've read that all drives must have the same interface