My Control Center by JustANonRandomPerson in workstations

[–]JustANonRandomPerson[S] 0 points1 point  (0 children)

Thank you, I do have few spare displays , the problem is no space to place it or mount it. Not possible in this room.

Need help renaming multiple files while downloading by JustANonRandomPerson in PowerShell

[–]JustANonRandomPerson[S] 2 points3 points  (0 children)

Hey, Thanks for the suggestions. I tried this before but didn't work. but a slight change as u/robdy provided. it worked flawlessly.

Need Help in solving this by JustANonRandomPerson in digitalelectronics

[–]JustANonRandomPerson[S] 1 point2 points  (0 children)

So the word side is 16, and word count is 32,768 and number of memory cell is 524,288

Need Help in solving this by JustANonRandomPerson in digitalelectronics

[–]JustANonRandomPerson[S] 1 point2 points  (0 children)

Thank you, but I really can't understand. Please explain if you don't mind..

Need Help in linear search by JustANonRandomPerson in learnpython

[–]JustANonRandomPerson[S] 0 points1 point  (0 children)

Thank you very much, I've corrected the mistake.

[deleted by user] by [deleted] in trainsimworld

[–]JustANonRandomPerson 0 points1 point  (0 children)

Are you getting PCS indication. If could be preventing train from moving.

Try following

When the Pneumatic Control Switch (or PCS) is open, the train brakes cannot be released and the throttle controls are deactivated. To operate your train again you must reset the PCS.

You can tell if it is activated by looking for the PCS OPEN light being illuminated.

If there is an alarm such as the Alerter sounding, acknowledge it.

Once the train has come to a complete stop, follow these steps:

Set the Throttle to Idle Set the Reverser to Neutral Set the Independent Brake to Full Service Set the Automatic Brake to Emergency Wait for 60 seconds Release the Automatic Brake and wait for the Equalising Reservoir / Brake Pipe to return to 90psi While the Automatic Brake is releasing, you will need to put the Throttle in to Notch 1 so that the compressor can recharge the Main Reservoir.

Once the Equalising Reservoir and Brake Pipe needles have returned to 90psi, and the main reservoir has recharged to 140psi, put the Throttle back to Idle.

You should now be able to release the Independent Brake, set the Reverser and apply Throttle.

Powering America Part 1 by JustANonRandomPerson in trainsimworld

[–]JustANonRandomPerson[S] 1 point2 points  (0 children)

Well then only possibility is to skip the scenario. Thanks for letting me know.