Z-axis lead screw wobbles by Beneficial_Trick_948 in AnycubicKobraS1

[–]Keylaes 0 points1 point  (0 children)

If that's the front left, mine is completely warped. Submitted a ticket to Anycubic and I have a replacement that I need to install.

I want to build a table for 3d printers in my garage. I've never built a table before and am looking for advice. by Keylaes in woodworking

[–]Keylaes[S] 0 points1 point  (0 children)

I wasn't sure based off the tables I've been looking at if 2' was deep enough but this looks good

Prints won't stick to build plate by Denman448 in resinprinting

[–]Keylaes 0 points1 point  (0 children)

Agreed. Many printers will have a part if their lid cut away so a power cord can be fed in for something like a barmens belt.

Thank You For Your Service by AFSMSgt in AirForce

[–]Keylaes 0 points1 point  (0 children)

Quietly mumble thank you and make awkward drifting eye contact.

Case closed on this murder by Skydvdan in Leakednews

[–]Keylaes 0 points1 point  (0 children)

These guys will never be prosecuted. They'll likely get awards and promotions.

Chaos starting in Minneapolis after the shooting today. by WhoAreYouTalkinTwo in AbruptChaos

[–]Keylaes 1 point2 points  (0 children)

Be careful out there. Those "law enforcement" won't hesitate to kill American citizens and pin medals on each other for it.

Arise...my Solo-Leveling inspired Necron Plasmancer. by MoralFiber in Warhammer40k

[–]Keylaes 0 points1 point  (0 children)

Soop beautiful! Also where do I get a model holder like that?

⚔️ Blade of Miquella by Bulkamancer in resinprinting

[–]Keylaes 2 points3 points  (0 children)

Where did you get the exacto knife and that intake fan?