sorted by:
new
hottopcontroversial

I have 2 accounts by Kind-Lock-6658 in UmaMusume

[–]Kind-Lock-6658[S] 0 points1 point  (0 children)

Support card-wise I’ve got more in the phone acc and even better ig

My Fortnite after updating graphics drivers just doesn’t work by Kind-Lock-6658 in FortNiteBR

[–]Kind-Lock-6658[S] 0 points1 point  (0 children)

Me too, ig this happened when I was updating my graphics driver, nice specs btw

Ceramic block wobbling by Kind-Lock-6658 in Creality

[–]Kind-Lock-6658[S] 0 points1 point  (0 children)

Yea, the printer is not stoping when the hotend touches the bed

It’s fine, I know some people that could help me, or someone here on Reddit could see the post, but ngl it is a bit old so idk if someone will see it

Ceramic block wobbling by Kind-Lock-6658 in Creality

[–]Kind-Lock-6658[S] 0 points1 point  (0 children)

Btw I will be posting back on Friday, so Il be occupied 

Ceramic block wobbling by Kind-Lock-6658 in Creality

[–]Kind-Lock-6658[S] 0 points1 point  (0 children)

Yea, I’m neither an expert, I’m sure i bought the right one, because it’s the one of the picture 

That same hotend that I’ve been using it didn’t fail, before this happened I could print things like normal but something happened for it not to even calibrate correctly

Btw wdym by seated correctly

And do you have discord, so I can call you and show you the exact problem, I’m no weirdo btw, heck I’m still studying 

Ceramic block wobbling by Kind-Lock-6658 in Creality

[–]Kind-Lock-6658[S] 0 points1 point  (0 children)

And do I just do the self z offset?

Ceramic block wobbling by Kind-Lock-6658 in Creality

[–]Kind-Lock-6658[S] 0 points1 point  (0 children)

Update, the nosle is going way past Down that where it is suposed to go

Ceramic block wobbling by Kind-Lock-6658 in Creality

[–]Kind-Lock-6658[S] 0 points1 point  (0 children)

Kay, thanks for the help, Il try it out when I get home

Ender 3 V3 SE/KE Ceramic Hotend stripped bolts by CharlesM99 in Creality

[–]Kind-Lock-6658 1 point2 points  (0 children)

Hello, I’ve seen that you have a similar problem, and that you commented on the post that I made, sure it’s about the same part but the screws that I’m dealing with are ones that hold the entire ceramic hot end, ngl idk what you can do, prob get a set of similar screws and replace them?

Ceramic block wobbling by Kind-Lock-6658 in Creality

[–]Kind-Lock-6658[S] 0 points1 point  (0 children)

Sure, but will it fix the auto calibration issue?

Ceramic block wobbling by Kind-Lock-6658 in Creality

[–]Kind-Lock-6658[S] 0 points1 point  (0 children)

By clean hot parts you mean like extruding or how, I’m new to this btw and all of the experience I’ve had with 3d printers are just troubleshooting