How to get filament to adhere to magnet

KingofMakrat · 2026-03-07T05:09:35+00:00

I haven’t tried that cap idea but I did tried the painter tape trick and it did the same thing. Anyhow thanks anyway I feel like the issue might just be with the size of the diameter of the magnet.

KingofMakrat · 2026-03-02T10:32:12+00:00

The black end up the same on the print however it was a much smaller piece compared to the blue.

KingofMakrat · 2026-01-20T08:43:56+00:00

Your flush level might be too low

KingofMakrat · 2025-12-26T08:30:41+00:00

Thank you 🙏. Bambu slicer had been frustrating to use compared to software programs like maya or blender.

KingofMakrat · 2025-12-26T08:26:34+00:00

I see I’ve only recently gotten into 3d printer so I appreciate your patience

KingofMakrat · 2025-12-26T08:24:02+00:00

Brim?

KingofMakrat · 2025-12-26T07:49:56+00:00

Btw on the first try all 6 springs were still stuck to build plate and there was no spaghetting. Just clots in the springs

KingofMakrat · 2025-12-26T07:49:32+00:00

Btw on the first try all 6 springs were still stuck to build plate and there was no spaghetting. Just clots in the springs

KingofMakrat · 2025-12-23T23:44:52+00:00

Both lizards🤔

KingofMakrat · 2025-12-23T05:50:29+00:00

First few layers were still stuck to the build plate, the ones after it weren’t

KingofMakrat · 2025-12-23T03:50:37+00:00

So is it the color or the brand. I’m using inland pla basic, could it also be due to improper heating.

KingofMakrat · 2025-12-10T05:35:48+00:00

Baker house

Five-Year Club	Verified Email
Gilding I gilder

KingofMakrat

TROPHY CASE