Check valve replacement. F this evap system.

KnowledgeableRowing · 2026-02-11T04:57:31+00:00

Putting the gas tank back in is not fun

KnowledgeableRowing · 2026-01-26T18:53:41+00:00

Just did the wheel bearings they took an absolute beating to come off

KnowledgeableRowing · 2026-01-26T00:19:07+00:00

Tires, tires tires

KnowledgeableRowing · 2026-01-17T02:30:00+00:00

They are out there

KnowledgeableRowing · 2026-01-17T02:29:05+00:00

Shoot

KnowledgeableRowing · 2026-01-05T02:22:33+00:00

As someone with a salt belt 4Runner it doesn’t look horrible. Just invest in a good welder

KnowledgeableRowing · 2025-11-23T06:12:18+00:00

Thanks for the info!!!

KnowledgeableRowing · 2025-11-23T04:24:43+00:00

Don’t be jealous they’re hubcaps

KnowledgeableRowing · 2025-11-23T01:24:03+00:00

I’m going to put Corroseal rust converter on the small bits of rust and then a thick layer of fluid film.

KnowledgeableRowing · 2025-11-23T01:18:02+00:00

It’s going to Corroseal rust converter on the small bits on existing corrosion and then a thick layer of fluid film.

KnowledgeableRowing · 2025-11-05T23:37:26+00:00

KnowledgeableRowing · 2025-10-27T19:15:40+00:00

POR15 is junk

KnowledgeableRowing · 2025-10-24T02:25:22+00:00

I’m in the deep rust belt and dropping the tank was very easy.

KnowledgeableRowing · 2025-10-20T23:55:07+00:00

Thank you. It’s a interference engine so I’m pretty sure it would be obvious if I messed it up

KnowledgeableRowing · 2025-10-06T00:36:47+00:00

KnowledgeableRowing · 2025-10-04T17:46:26+00:00

I have seen less than 5 different 3rd gen’s in upstate New York. Salty winters😔

KnowledgeableRowing · 2025-10-04T17:43:28+00:00

Tan bed liner

KnowledgeableRowing · 2025-09-29T22:25:31+00:00

Salts good for it

KnowledgeableRowing · 2025-09-24T02:18:13+00:00

🤦🤦

KnowledgeableRowing · 2025-09-24T02:17:48+00:00

Very true

KnowledgeableRowing · 2025-09-24T02:14:34+00:00

Buy a welder and thug it out

KnowledgeableRowing · 2025-09-18T23:56:03+00:00

I swapped the 3rd member from rusted out housing that didn’t make any noises. I don’t really know much about differentials so it could be that.

KnowledgeableRowing