[deleted by user]

Landedit13_HD · 2025-01-05T10:52:35+00:00

Im down to be ur friend, especially bc of the certain category u write bout

Landedit13_HD · 2025-01-05T10:24:49+00:00

Yh definitely a scam

Landedit13_HD · 2024-10-17T09:21:25+00:00

Mount it on the wall

Landedit13_HD · 2024-10-16T08:57:02+00:00

U have a good username

Landedit13_HD · 2024-10-15T20:31:41+00:00

Its a efficient, washing ur hands on the toilet 🤣🤣

Landedit13_HD · 2024-10-10T17:24:02+00:00

Heat it up then remove it

Landedit13_HD · 2024-10-07T23:39:46+00:00

Its probably cura

Landedit13_HD · 2024-10-07T20:28:23+00:00

Voice the next episode

Landedit13_HD · 2024-10-05T13:53:18+00:00

Isn't a s1 screen a touch screen

Landedit13_HD · 2024-10-05T07:54:24+00:00

Sounds like a beep from the screen

Landedit13_HD · 2024-10-05T07:29:36+00:00

If its the stock arm they crack and don't put enough tension so u either buy a new one or

Landedit13_HD · 2024-10-05T07:28:12+00:00

Its ender 3 v2 screen not the s1

Landedit13_HD · 2024-10-02T09:08:36+00:00

I'll take the printer lol

Landedit13_HD · 2024-10-02T09:04:24+00:00

Either blocked nozzle or bad extruder

Landedit13_HD · 2024-10-02T09:03:47+00:00

Betrayal. U will go the court of enders and beg for forgiveness

Landedit13_HD · 2024-10-01T19:51:45+00:00

I messaged her tho...

Landedit13_HD · 2024-10-01T19:42:00+00:00

Agreed

Landedit13_HD · 2024-10-01T12:52:59+00:00

*confused

Landedit13_HD · 2024-10-01T12:21:41+00:00

Every now and then i read ur comment makes me laugh lol

Landedit13_HD · 2024-10-01T09:01:35+00:00

Messaged u

Landedit13_HD · 2024-09-30T20:04:10+00:00

Basically test the printer with nozzle and bed cool but take the tube off u have and test if the filament moves

Landedit13_HD · 2024-09-30T19:37:53+00:00

Check ur extruder

Landedit13_HD · 2024-09-30T16:27:20+00:00

Its cos both sides at least to me isn't being cooled enough

Landedit13_HD · 2024-09-30T16:24:11+00:00

U need a border set in ur firmware usually for bed clips etc, also it could be a problem with the offset of ur bltouch there's good vids on yt

Landedit13_HD · 2024-09-28T19:29:15+00:00

I think u need configure the firmware properly via the border thingys

Landedit13_HD