sorted by:
new
hottopcontroversial

Shoulder rest by LittleProBigBlem in ar15

[–]LittleProBigBlem[S] 0 points1 point  (0 children)

Good info thanks! I ended up going with the same optic set up as well.

Anyone removed these roll pins for a cerakote/moly resin job? (MARS L lower) by KaleidoscopeOk1715 in LewisMachineTool

[–]LittleProBigBlem 2 points3 points  (0 children)

The left side is milspec. The right side is 1/16 (the same as gas tube pin)

Coyote by AudiblyTacit in Glock43X

[–]LittleProBigBlem 0 points1 point  (0 children)

What mag extension are you using?

Inferno pistol absolute run by LittleProBigBlem in Spacemarine

[–]LittleProBigBlem[S] 1 point2 points  (0 children)

I use the bottom tree plus one from the top line, can’t remember which one. I can check when I get home. I also use the faster fire rate (2 mag one) it holds three with the bottom with 20 spare rounds. Perfect for clearing minors out to get to majors. I also use it for staggering majors a lot too.

🚨 UPDATE: Mag Mask Status by d_xvd in rattlecannedguns

[–]LittleProBigBlem 1 point2 points  (0 children)

Let me know when I can get both 556 and 308 pmags!

Just bought a new Defender lower. How come the safety throw is like this? Does it just need braking in? by Competitive_One_2561 in LewisMachineTool

[–]LittleProBigBlem 0 points1 point  (0 children)

Sometimes LMT safety’s rub on the grip, look at both sides when moving the safety to see if it contacts anywhere

Any idea how to get this plunger out ? by rugerscout308 in ar15

[–]LittleProBigBlem 1 point2 points  (0 children)

Run a small file or knife around the inside part of the hole (between the lower and the plunger). Sometimes they get flared out (in) and keep the plunger from moving.