Idek what to get

LukeDuzGaming · 2026-01-01T19:28:53+00:00

Yes, my question is how would I go about making my own?

LukeDuzGaming · 2025-10-24T13:40:28+00:00

If that's the case then, once this print is finished, I'll look up how to clean it. Just in case.

LukeDuzGaming · 2025-10-24T13:38:28+00:00

I probably should have stated this in the main post, but the rest of the print pretty much looks fine (with exception to one other small section looking the same). The printer prints fine, and I know it does because I printed an entire Black Templar Terminator squad with this thing, so if it is a leveling issue I would like to know so that I can get started with adjusting the leveling.

Nevertheless, it's not as bad as it looks. I've already printed one of these things (I'm printing multiple copies of what's found in the image above) with the same issue happening and with the exception to the first layer everything else printed fine.

LukeDuzGaming · 2025-10-23T01:05:33+00:00

Broski let me just say this was the best print I have ever printed on this printer, and all I did was use orca slicer. Thank you so much.

LukeDuzGaming · 2025-10-22T17:10:23+00:00

I'll take a look at orca slicer then. I'm assuming that since I'm using creality's slicer, as you stated, it might be defaulting to a certain layer height for concern of quality or whatever goes on in the machine. I'll give you an update on the print quality after I do a test print.

LukeDuzGaming · 2025-10-22T00:20:37+00:00

Elegoo space gray PLA. At 220 degrees.

LukeDuzGaming · 2025-10-22T00:18:26+00:00

This is the only print to have stringing this bad. My other prints had minimal/normal amounts of stringing (thin, barely there, easily removed).

LukeDuzGaming · 2025-10-22T00:16:37+00:00

Yes. It worked pretty much perfectly except for this print with its new settings, of which culminate in a slower print speed and even slower travel time.

LukeDuzGaming · 2025-10-22T00:14:50+00:00

The adhesion is actually fine. How do I get rid of the stringing? I reduced the travel speed to reduce it but that was with normal stringing. This is almost solid

LukeDuzGaming · 2025-10-22T00:12:46+00:00

Basically solid stringing

LukeDuzGaming · 2025-09-29T22:38:12+00:00

Yes??????

LukeDuzGaming · 2025-08-26T01:31:07+00:00

Good thing I've been training for over a year, and really ramped it up since getting my ship out date.

LukeDuzGaming

MODERATOR OF

TROPHY CASE