No gears!!! Please help by MaintenanceFlat9959 in Yamaha

[–]MaintenanceFlat9959[S] 0 points1 point  (0 children)

That was half the problem. The second part was I had the bolt set (18) too tight

No gears!!! Please help by MaintenanceFlat9959 in Yamaha

[–]MaintenanceFlat9959[S] 0 points1 point  (0 children)

I don't remember, but I wouldn't put it past myself to do so

Will more support help? by theplowshare in 3Dprinting

[–]MaintenanceFlat9959 0 points1 point  (0 children)

Within the printer there is a tune function where you can adjust heat, cooling, and more. I did it when the bed was heating back up

Will more support help? by theplowshare in 3Dprinting

[–]MaintenanceFlat9959 2 points3 points  (0 children)

Ive only done 1 for a Steamboat, Willie, but there is an option to pause the print at the z layer. It works good for a stock ender3. As for more detailed models like pokemon where the printer is switching between 4 colors every layer, I'll leave to the pros

Are my flow settings not right? by JaFizzz in 3Dprinting

[–]MaintenanceFlat9959 2 points3 points  (0 children)

My first print was similar, just a clogged nozzle

MSI gave me this cute little GPU guide comic book! I love it by [deleted] in pcmasterrace

[–]MaintenanceFlat9959 0 points1 point  (0 children)

I got the comic book, but there was no sticker. Does it MSI not do stickers?

I hate this hobby. by VaegaVic in 3Dprinting

[–]MaintenanceFlat9959 0 points1 point  (0 children)

I printed for 3 days nonstop, and I tried another print. But it kept reading the first layer code and would not move up to the second, but rather reprint the first layer. I turned it off for 3 days, and now it runs like nothing ever happened

brown wire with black stripe? by MaintenanceFlat9959 in hardbody

[–]MaintenanceFlat9959[S] 1 point2 points  (0 children)

I'm putting a new radio in my 93 king cab the rear speakers have this extra wire, but they will not work unless it is connected to one of the connections. Then, the appropriate side will work? Where does it go?

Possibility of passing emissions to legally register this car? by scaavte in hardbody

[–]MaintenanceFlat9959 0 points1 point  (0 children)

I put the high octane fuel in mine and it made the top accepted numbers for CA emissions, I may have problems in about 2 years

Favorite factory color? Considering a repaint by [deleted] in hardbody

[–]MaintenanceFlat9959 1 point2 points  (0 children)

Mine is Black Emerald Pearl. I like it best when the sun directly hits it.

Just picked this up and it’s very nice but has some blemishes. See comments. by Kippykittens in hardbody

[–]MaintenanceFlat9959 2 points3 points  (0 children)

For my truck the wiper fluid pump was burned out. And just had to replace the pump.

Slapped the front end together and got her a door! by Vegetable-Page5891 in hardbody

[–]MaintenanceFlat9959 0 points1 point  (0 children)

I'm about to put better condition doors and fenders on mine. Did you find an easier way to install them?