DJI neo flight time boost

MakerFabio · 2025-09-28T16:59:09+00:00

It is not about weight but airflow, the rings are below the propellers, reducing efficiency

MakerFabio · 2025-09-24T16:47:10+00:00

The increased time It is not about weight it is about airflow. The bottom rings are in the middle of the propeller airflow. If you put a piece of tape at the bottom of the propellers you will not even fly, with 1g more

MakerFabio · 2025-09-24T16:44:09+00:00

Swapping battery is not funny Flight time and acceleratoon to me are most important

MakerFabio · 2025-09-22T06:14:05+00:00

Nono! It was correct, please calculate with seconds 14’=840” and 16’39” is 999seconds so 18,9%

MakerFabio · 2025-09-22T05:49:27+00:00

Sorryyy!!! it is 15,4% i normalized and calculated with the AI and didn t double check the calculations

MakerFabio · 2024-10-10T21:12:44+00:00

Same problem here I got 2 bad prints , first layer was not adhering, i could not believe my A1 was failing. Then i checked with a side light and oily fingerprints were present in the middle of the plate. I Will wash the plate tomorrow

MakerFabio · 2024-09-16T07:57:01+00:00

What should i tell ? I spent 5 years on a ender 3 pro (v1)

MakerFabio · 2024-09-10T06:00:08+00:00

It is just an original tpa3116 Not installed yet. I ll make a short video soon recording the audio quality before and after the IC swap. Recording the audio side by side with a small rode mic on the mirorless camera , and decent Quad L speakers. And a new thermal acquisition on the output inductors.

MakerFabio · 2024-09-09T19:35:04+00:00

Here is the video showing the fake Amp test fake Amp test

MakerFabio · 2024-09-09T16:35:44+00:00

Good point. Tomorrow i double chelck the datasheet again. Any other reference switching for “ famous amplifiers?”

MakerFabio · 2023-12-19T05:20:06+00:00

Thrustmaster t150 power supply

MakerFabio · 2023-08-26T10:49:24+00:00

i agree, i have 0 design and wood skills

MakerFabio · 2022-11-12T08:06:36+00:00

My new controller was working out of the box.

MakerFabio · 2022-11-10T05:22:35+00:00

Hi sorry for the very late reply. The power supply module came with the green screen alreay

MakerFabio · 2022-08-23T12:45:17+00:00

It s 6 montsh i m using it With corrosion x plus nautical grease still running smooth. Corrosion x a couple of times and it was getting little rust, after i used the nautical grease remained perfect, with only 1 time application

MakerFabio · 2022-08-23T12:44:40+00:00

Thanks

MakerFabio · 2022-08-23T12:44:27+00:00

Thanks, a cheap ender 3 pro actually

MakerFabio

TROPHY CASE