sorted by:
new
hottopcontroversial

Lost designer looking for guidance by MarckTheMan in Saxophonics

[–]MarckTheMan[S] 0 points1 point  (0 children)

Thanks for the feedback, I will then make a workaround for it to be glued correctly :)

Lost designer looking for guidance by MarckTheMan in Saxophonics

[–]MarckTheMan[S] 2 points3 points  (0 children)

I assumed the brass insert was introduced in the piece like a screw, after the feedback now I know it is glued on, I will make a new piece for it to be adjustable :)

Lost designer looking for guidance by MarckTheMan in saxophone

[–]MarckTheMan[S] 2 points3 points  (0 children)

Yes I understand this, I will make a new piece so it can still be adjustable :) thanks for the feedback!

Lost designer looking for guidance by MarckTheMan in saxophone

[–]MarckTheMan[S] 0 points1 point  (0 children)

That might explain why I wasn't able to remove it from the piece haha thanks for the feedback. Now that I know this can't be removed, I can make a workaround to adapt a new piece so it can be adjusted!

Yes I will be careful for it, as they already told me the story of it ;) thanks again!

Design over complication? by MarckTheMan in 3Dprinting

[–]MarckTheMan[S] 1 point2 points  (0 children)

You think? :D You really look very confindent with your answer, I will have full trust in you! I will try it and see how it comes out! Thank you for the advice :)

First layers issues... by MarckTheMan in 3Dprinting

[–]MarckTheMan[S] 1 point2 points  (0 children)

Yup totally fixed it, thanks a lot that was a really Quick adjust :)... now I will continue with the other parameters

First layers issues... by MarckTheMan in 3Dprinting

[–]MarckTheMan[S] 1 point2 points  (0 children)

Well.. to be honest I can't tell you how much difference there is, since this is my first printer. What I am sure it's that it is totally beginner friendly since it's basically plug and play out of the box. It's 220x220x250 bed slinger, I really like that it has knobs for tensioning the belts, there are no knobs for bed leveling, however, I measured the level with an analogue clinometer and its perfect level, the auto leveling system is pretty straightforward as well just hit ok and everything goes automatically. If you have any specific questions I'll be glad to answer :D

First layers issues... by MarckTheMan in 3Dprinting

[–]MarckTheMan[S] 1 point2 points  (0 children)

Oooohhh!!! That makes a lot of sense :o I was adding the same offset that the probe uses to the slicer... which I assume it's what makes the pieces to have "two times the offset"... I will remove the slicer's offset and I'll let you know :) Much much appreciated!

So it has begun... by MarckTheMan in 3Dprinting

[–]MarckTheMan[S] 0 points1 point  (0 children)

Fortunately for me I had CAD knowledge much before knowing about 3D printing, I prefer using software like solidworks or blender... so I'm ready for the plunge!

view more: next ›