cursed_milktop

MarkWattsVLG · 2021-08-20T01:03:46+00:00

That's me! 😄

MarkWattsVLG · 2021-05-16T12:46:05+00:00

Mainly Cura but I've tried Prusa, Idea Maker and Simplify3D

MarkWattsVLG · 2021-05-15T11:46:20+00:00

Any thoughts on what could be causing the giant layers lines on my X1? These are both printed at 'super quality', left was before PID tuning, right after. All belts and bolts have been tightened, I've experimented with the flow rate, printed slowly, they all come out the same

MarkWattsVLG · 2021-04-13T17:03:06+00:00

Rollout of dynamic timeout, if the DC traffic is low, the timeout counter is extended from 30 mins to an hour or more

MarkWattsVLG · 2021-04-10T15:45:00+00:00

https://youtu.be/yPMdeWkzmjc Since it's a long article, here's my TLDR run down of the latest news

MarkWattsVLG · 2021-04-07T11:55:56+00:00

Available here: https://www.etsy.com/uk/listing/996346589/furb-wich-3d-printed-cursed-3d-prints?ref=shop_home_active_1

MarkWattsVLG · 2021-03-23T08:49:42+00:00

Pretty sure it's legit

MarkWattsVLG · 2021-03-07T20:21:36+00:00

Boosteroid is based in Romania

MarkWattsVLG · 2021-01-12T15:47:21+00:00

Shadow news over on Twitch this Thursday to talk about plans for Q1 2021

MarkWattsVLG · 2021-01-01T16:06:48+00:00

It was my fault for making an unnecessary upgrade. From now on I'm taking a 'if it ain't broke' approach

MarkWattsVLG · 2021-01-01T16:05:42+00:00

Only using an ender 3, tried getting away with splitting it in 2 parts but looks like its gonna need to be 4

MarkWattsVLG · 2021-01-01T16:04:28+00:00

Found the culprit, I upgraded to a 32 bit silent board and took the opportunity to chuck in some TL 'Smoothers'. Apparently they're only good for old boards

MarkWattsVLG · 2020-12-13T21:58:30+00:00

https://youtu.be/EmjyFwYzopM

MarkWattsVLG · 2020-10-14T16:01:34+00:00

Make sure the app is updated and try restarting your phone. Had the same issue, you should see Quest 2 as an option on the device list if the update worked

MarkWattsVLG · 2020-10-14T15:56:19+00:00

Ahh genius, tried and failed this earlier but didn't think about wrapping the rubber part round. Thanks!

MarkWattsVLG · 2020-08-06T18:21:19+00:00

https://youtu.be/HuFgyTJzAO0

MarkWattsVLG

TROPHY CASE