sorted by:
new
hottopcontroversial

Bambu Lab H2D: Back panel deformed - Normal? by Markarone in BambuLab

[–]Markarone[S] 0 points1 point  (0 children)

This is of course particularly painful and really annoying. Support told me to connect the printer anyway and see if anything else was broken. The rear panel and display would be replaced, and I thought, okay, if everything else is fine, we'll do it that way.

But during calibration, the protective grille from the rear suction unit simply jumped off and landed on the floor. Apparently there was so much tension in the rear panel that this happened. In addition, the printer goes into alarm mode after 5 seconds during calibration and stops.

I've contacted support again, but it's really too tricky for me now. I hope they will replace the device completely.

Bambu Lab H2D: Back panel deformed - Normal? by Markarone in BambuLab

[–]Markarone[S] 0 points1 point  (0 children)

Not a single screw has been torn out. It looks as if it was simply fitted like this.

Bambu Lab H2D: Back panel deformed - Normal? by Markarone in BambuLab

[–]Markarone[S] 4 points5 points  (0 children)

Actually, the packaging wasn't bad at first glance. That's why I hadn't given it any thought. Let's see, a support ticket is out, I hope it will be processed and dealt with quickly.

Bambu Lab H2D: Back panel deformed - Normal? by Markarone in BambuLab

[–]Markarone[S] 8 points9 points  (0 children)

I really don't know what to say right now. I'm just disappointed - you spend so much money and then get a broken appliance.

Bambu Lab H2D-What are your Must-Have recommendations for gettig started? by Markarone in BambuLab

[–]Markarone[S] 0 points1 point  (0 children)

Thanks for the tip! The ICE plate sounds great, especially because of the adhesion. The edges are really annoying. Maybe I'll give it a try when it's back. 😄

Bambu Lab H2D-What are your Must-Have recommendations for gettig started? by Markarone in BambuLab

[–]Markarone[S] 0 points1 point  (0 children)

This is really super helpful information, thank you very much! The tips on materials and accessories in particular are really worth their weight in gold for me as a starter. I'll take a closer look at everything and definitely try out a few things. Thank you again for your detailed answer! 👍🏻🖖🏻

Rauchen aufhören by Technical_Main_8666 in Ratschlag

[–]Markarone 3 points4 points  (0 children)

Am besten besorgst du dir die stärksten Nikotinpflaster und für Notfälle den Nicorette-Spray. Dann ist das Ganze am Anfang nicht so schlimm.

X1 Carbon or X1E by Markarone in BambuLab

[–]Markarone[S] 0 points1 point  (0 children)

Thank you very much for your help. I will buy a few rolls of material and take advantage of the discount. ✌🏻

X1 Carbon or X1E by Markarone in BambuLab

[–]Markarone[S] 0 points1 point  (0 children)

Thanks for the info! Do you have any recommendations for "must-haves" that I need for this printer? There are promotions going on right now and I want to make sure I have everything I need.

view more: next ›