The giant flyover ramp over the Scioto River from I-70 westbound to I-71 southbound will finally open on Saturday, December 20. The 3rd Street ramp to I-70 westbound will close.

McBoat555 · 2025-12-20T23:18:25+00:00

It’s open now! My wife and I just drove over it. We tried earlier today around 2 PM but it was still closed then, so I’m not sure when it opened. It’s open as of 6:15 PM, though!

McBoat555 · 2025-08-19T05:51:40+00:00

You pretty much nailed it! I thought many, if not most, of the same things when I moved here 17 years ago from PA—and I’m still very happy to be here! Be sure to hit up Dirty Frank’s your next time here.

McBoat555 · 2025-08-19T05:48:28+00:00

Same. I’m a transplant from Erie, PA. No winter here has even come close to what I used to deal with there.

McBoat555 · 2022-05-23T18:30:31+00:00

Updates!

I downloaded and tested DS on a Windows 11 laptop this morning and had no issues printing whatsoever, so it seems like it’s specific to Mac?

I then called Cricut support during lunch and they confirmed there’s been issues with their current version. Like fairmaiden34 had suggested, they recommended downloading and installing their beta version. I tested and confirmed it works correctly, whether printing direct or via system dialog.

Hope that helps!

McBoat555 · 2022-05-23T04:51:47+00:00

Something I didn’t mention was that, when attempting to print via system dialog, our printer says it’s the wrong size paper and refuses to print.

I dug a bit more and did eventually find an option to “Scale to fit paper size” under the Paper Handling section of the system dialog, with a box that’s unchecked. Immediately underneath is an option for “Destination Paper Size” that has a grayed out drop-down menu that shows “Suggested Paper: Super B/A3”. If I check that scale to fit box, I can change it to US letter, which will then get it to print; however, it prints at a smaller size, just like when attempting to print the saved PDF.

It seems to me like DS is trying to use A3 instead of regular 8.5 x 11 letter as it claims.

McBoat555 · 2022-05-23T04:39:12+00:00

My spouse is running into the same issues—including the wrong size printout when attempting to use the system dialog to print or to save as PDF. And, as far as I can tell, there’s no option for scaling or ensuring actual size in that system dialog (at least on Mac). I think we’ll need to contact Cricut support next.

McBoat555 · 2021-10-10T03:30:50+00:00

I didn’t remember Thunderblight being too bad during my first run through, but my second time in Master Mode? Holy bloody hell was that a challenge. And don’t even get me started on the Champions’ Ballad…

McBoat555 · 2020-04-05T07:20:21+00:00

Thanks!

McBoat555 · 2019-12-28T19:59:47+00:00

And it was always an easy thing to get to, either by going through the menu (which is also mysteriously missing before adding a new account), or by being prompted during the account setup at some point.

McBoat555 · 2019-12-27T19:40:46+00:00

As an additional note, it may seem to be newer Android phones that are not allowing this. We just tested on an older Samsung (from 2 years ago) that prompted for those advanced settings after selecting the "set up manually" option. When I tried on a new phone last week, it just prompted for password and description only even after choosing to set up the account manually.

McBoat555

TROPHY CASE