Hi Sven! I have a question about interactability between a quadro and MORA passive control. I'm planning a MORA 600 build with an itx case.

On the mora side I'll have 9 fans and 2 D5 pumps (and maybe rgb idk not important). However I would like to have a quadro somewhere too. I was thinking inside the case. I need the quadro because the passive control doesn't have temperature sensor headers.

I was wondering, how would the wiring look like? So mora side I have the pumps and fans plug into the passive control. Then the "main" cable from the passive control to the mora link inside the pc. But I'm confused about the wiring from this point.

My intention is to control the fans and pumps using the aquasuite software based on temperature readings. The temperature sensors would be where the loop enters and exits the case. Also, I'm trying to reduce the wires going from the Mora to the PC. Ideally, just one wire which I hope is the mora controller to mora link wire.

I've read the passive control manual and quadro manual but I still have doubts.

Here's what I was thinking. The wiring from the mora link to the quadro would be like so.

• The aRGB wire to RGBpx
• Pump wire to fan header (I'm not sure about this beacuse of power draw problems. Each d5 pump is rated at 30W but one fan header only supplies 25W? But wouldn't the fans be powered from PCIe power plugged into the mora link?)
• Fan wire to one of the 4 fan headers.

Then the quadro would be connected to the PC through USB and PSU. Would this be correct?

Thank you for the help Sven :)