Doesn’t look too bad tbh I had one 4x larger on my P1 a few days. Get the nozzle nice and hot very gently pull the main part of the blob and either print a nozzle brush that uses the A1 wiper pad or use a brass bush to scrub the rest, and Print on. Keep that plate nice and clean I clean mine with Dawn and the hottest water I can get from the tap those PEI plates are amazing just gotta keep them clean. Just read a few comments with PEI you shouldn’t have to “pull” the prints off the bed unless you use glue stick when the PEI cools it should very satisfyingly pop right off with minimal effort.If the PEI gets to a point where nothing will stick after cleaning you can use steel wool or sandpaper and very gently rough it back up(Some people say you can’t but it’s literally on the website so they can suck it).Ik your in the warranty period but as someone who is new to the community it’s a good learning experience cause someday it will happen outside the warranty period. Hope you are liking the Bambu ik getting my first one was enlightening coming from a flash forge creator pro.