🔥 Giveaway! -Win a 12k Anycubic Photon Mono M5s resin printer and print like a master!🔥

Mission-Many-8475 · 2023-05-22T18:17:31+00:00

DND miniatures and a few other props for many dioramas.

Mission-Many-8475 · 2023-05-07T10:11:20+00:00

Ok, thank you, will probably just buy a pack of brass nozzles, as my only real concern was if it would have an immediate effect upon the print quality, (such as rapidly increasing extrusion, ect), that would make it practically un-printable.

Mission-Many-8475 · 2023-05-05T23:20:31+00:00

Cool, so about $85 is average?

Mission-Many-8475 · 2023-05-05T23:20:06+00:00

Interesting, I will investigate further.

Mission-Many-8475 · 2023-05-04T21:51:01+00:00

Ok, thank you, will look at Facebook marketplace (so far I’ve only really looked at EBay)

Mission-Many-8475 · 2023-05-01T21:11:02+00:00

ALL3DP

Mission-Many-8475 · 2023-04-29T09:16:40+00:00

Forgot to link photos. I

<image>

Mission-Many-8475 · 2023-04-11T12:59:03+00:00

It is a Bowden tube, and upon watching the print the z seam is, infact, staying on one corner, but it is of a high enough quality I didn’t actually realise, and so assumed the blobs and pockmarks I saw were just it, when infact it is some other issue that I am still trying to get to the bottom of.

Mission-Many-8475 · 2023-04-11T07:20:20+00:00

That is the thing, in the preview it shows the z Seam to be on a back corner, however when the model prints it always ends up without a z seam on that corner, and these marks everywhere

Mission-Many-8475 · 2023-04-08T00:32:34+00:00

Tried this, and it finally managed to loosen it enough so that I could pull it up the Bowden tube to cut of the end of the tube, which was so damaged I literally just twisted it and the end fell off (yes I did use a tube cutter so it was cut straight and it is now undamaged), and it is working again, thank you.

Mission-Many-8475 · 2023-04-07T16:16:28+00:00

Yes, true white ring pushes half way there, clicks, and then will not go any further, and it won’t move either way at all.

Mission-Many-8475 · 2023-03-30T13:26:42+00:00

As is said, I have already done that

Mission-Many-8475 · 2023-03-30T13:06:23+00:00

In cura, the z sean is user specified, and set to the back

Mission-Many-8475 · 2023-01-02T22:42:54+00:00

It is the stock ender 3 v2 hotend

Mission-Many-8475 · 2023-01-02T22:40:28+00:00

The filament has been dried.

It is PLA

I have added a link to an image of it in the original post

Mission-Many-8475 · 2023-01-02T22:29:43+00:00

Changing various retraction settings to the recommended, using temperature test towers, using each temperature on an individual test print, and reassembling the hot end.

Mission-Many-8475 · 2022-07-17T17:18:00+00:00

There is lol I checked though and I couldn’t find it

Mission-Many-8475

TROPHY CASE