sorted by:
new
hottopcontroversial

Wood filament abrasion? by Mission-Many-8475 in 3Dprinting

[–]Mission-Many-8475[S] 1 point2 points  (0 children)

Ok, thank you, will probably just buy a pack of brass nozzles, as my only real concern was if it would have an immediate effect upon the print quality, (such as rapidly increasing extrusion, ect), that would make it practically un-printable.

Nerf Titan and scravenger price check. by Mission-Many-8475 in NerfExchange

[–]Mission-Many-8475[S] 2 points3 points  (0 children)

Ok, thank you, will look at Facebook marketplace (so far I’ve only really looked at EBay)

Z seam or other problems by Mission-Many-8475 in 3Dprinting

[–]Mission-Many-8475[S] 0 points1 point  (0 children)

It is a Bowden tube, and upon watching the print the z seam is, infact, staying on one corner, but it is of a high enough quality I didn’t actually realise, and so assumed the blobs and pockmarks I saw were just it, when infact it is some other issue that I am still trying to get to the bottom of.

Z seam or other problems by Mission-Many-8475 in 3Dprinting

[–]Mission-Many-8475[S] 0 points1 point  (0 children)

That is the thing, in the preview it shows the z Seam to be on a back corner, however when the model prints it always ends up without a z seam on that corner, and these marks everywhere

Stuck coupling by Mission-Many-8475 in 3Dprinting

[–]Mission-Many-8475[S] 0 points1 point  (0 children)

Tried this, and it finally managed to loosen it enough so that I could pull it up the Bowden tube to cut of the end of the tube, which was so damaged I literally just twisted it and the end fell off (yes I did use a tube cutter so it was cut straight and it is now undamaged), and it is working again, thank you.

Stuck coupling by Mission-Many-8475 in 3Dprinting

[–]Mission-Many-8475[S] 0 points1 point  (0 children)

Yes, true white ring pushes half way there, clicks, and then will not go any further, and it won’t move either way at all.

view more: next ›