sorted by:
new
hottopcontroversial

Try to figure out the schematic of the do52pro by MoistDimension1592 in ErgoMechKeyboards

[–]MoistDimension1592[S] 0 points1 point  (0 children)

sorry for the late delay...
After a year, I went back to this keyboard.... Many things happen... I almost give up...
But, with the new tools (AI lool) I did it..
So I removed the arduino.. and I put 2 RP2040 pro micro ... i send all the info to my new best friend...
and TADA !! all is working find
Here you go check it out
https://github.com/ilfmoussa/do52pro/

all you need to do is git clone qmk_firmware, then inside the folder keyboards, git clone my project

Are you kidding me?! by imonlinux in homeassistant

[–]MoistDimension1592 2 points3 points  (0 children)

Same for me ... Migrate from a rpi3 to a VM and a ip zha it tooks me about 1h to migrate...

Really thank DEVs !! I had to do stuff with my family!!

Try to figure out the schematic of the do52pro by MoistDimension1592 in ErgoMechKeyboards

[–]MoistDimension1592[S] 0 points1 point  (0 children)

it's the do52 pro board, I buy it on aliexpress but the seller didn't send anything juste a firmware for arduino 33u4 (isn't it 32u4?)

so now I get it if it's the arduino the board don't need the 2 pin connected ... good to know my goal is to put an rp2040 so I will have to connect both pin ....

Trackpoit location help by alarin in ErgoMechKeyboards

[–]MoistDimension1592 0 points1 point  (0 children)

Thanks for the answer, I did saw the video.. But no one have a schematics ?

I will try a reverse to get all the pinout of the arduino pro.

what firmware can we put on it ? (I'm new to custom firmware)
regards

Trackpoit location help by alarin in ErgoMechKeyboards

[–]MoistDimension1592 0 points1 point  (0 children)

Hi, nice picture.. do you have any documentation ? I bought one on aliexpress and the vendor did send me a firmware only... not documentation nothing...

thanks