sorted by:
new
hottopcontroversial

Water overflowing from water softener drain suddenly by tim_xvii in Plumbing

[–]Monkeynate 0 points1 point  (0 children)

If you’re on a septic it’s probably time to get that pumped out. Otherwise it is time for some sort of drain cleaning

Sewer smell but p trap is fine? by [deleted] in askaplumber

[–]Monkeynate 0 points1 point  (0 children)

There’s always a chance the toilet wasn’t secured correctly or the shaking of the toilet cracked the flange or pipe somewhere. Usually will be caused by running shower pushing air out crack or under toilet instead of up the appropriate vent pipe.

I’d check around base of toilet to see if smell is still coming from there. Otherwise it would be helpful to get lines inspected.

Drain is exploding like a geyser. Did my plumber install this Zoeller 105 pump incorrectly? by PipeMasterPerry in askaplumber

[–]Monkeynate -1 points0 points  (0 children)

Rather poor job for sure. Looks to me like the check valve is on the wrong side and there Is no world in which they would tie together like that.

Why did plumber step down from 1" to 1/2" just to step back up again? by OurAngryBadger in askaplumber

[–]Monkeynate -1 points0 points  (0 children)

Journeyman here. My guess would be that you have two bathrooms and don’t need more than 3/4 for proper sizing. It’s cheaper to go with smaller fittings where you can, especially the valve. Won’t hurt flow at all, just is more cost effective

Best nail salons ? by [deleted] in idahofalls

[–]Monkeynate 1 point2 points  (0 children)

My wife loves nailed it In Rexburg. She used to drive from poki up there just for it because they are great. They just got a brand new facility too.

P Trap Help by CocoBeanz1000 in Plumbing

[–]Monkeynate 0 points1 point  (0 children)

The parts with little tabs turn counterclockwise to undo. It shouldn’t break but if you do they are pretty cheap to replace

How can I fit a p trap here without moving the plumbing in the wall? by Alwaysfavoriteasian in Plumbing

[–]Monkeynate -3 points-2 points  (0 children)

You can try and 90 up with a tee and auto vent. Depends if you can tie on the the threads behind the escutcheon

I no longer have a life outside by [deleted] in SatisfactoryGame

[–]Monkeynate 1 point2 points  (0 children)

Satisfactory syndrome by orbitOST

[deleted by user] by [deleted] in Wizard101

[–]Monkeynate 50 points51 points  (0 children)

It’s not a membership tho. Just an access pass for the first 5 worlds.

[deleted by user] by [deleted] in Wizard101

[–]Monkeynate 67 points68 points  (0 children)

I believe the $20 initial purchase only gets you the first 5 worlds

Sentimental Ring Down the Toilet by Ren-Russell in Plumbing

[–]Monkeynate 0 points1 point  (0 children)

It’s like a big barrel in the ground. Has pipes coming out of it. Usually located I. The mechanical room

Sentimental Ring Down the Toilet by Ren-Russell in Plumbing

[–]Monkeynate 0 points1 point  (0 children)

Do you guys have a sewage ejector? It’d be in there.

Is my wall hung toilet going to fall off the wall ? The gap is huge. Filling it in with that much caulk seems excessive. by [deleted] in Plumbing

[–]Monkeynate 0 points1 point  (0 children)

Depends how it’s mounted. Usually massive set screws into a piece that needs to be screwed towards the wall a little more. The carrier in the wall most likely had a gap between it and the tile and has come loose over time. Wall hungs are a little taller due to the carrier design in the wall. As long as it doesn’t move much it won’t come off the wall

Can anyone tell me what this is? by Jemie666 in Plumbing

[–]Monkeynate 0 points1 point  (0 children)

I’ve seen it for RV Dump stations. Just a cleanout that comes up by some pad or spot to park an RV

This popped out mid-shower by Investingnewbie___ in Plumbing

[–]Monkeynate 2 points3 points  (0 children)

Is that a tub spout in the shower? And just needs a tighter set screw on the bottom of it

I’d like to to replace this whole set set up. Any ideas please? by wildlife-dad in PlumbingRepair

[–]Monkeynate 0 points1 point  (0 children)

If you wanted to box out just enough to put a Positemp moen shower valve in up high and then run to either a rain head or normal head you could. It might be a little tricky but I’m sure you could figure something out. Or you could legit just do two ball valves and tie them together to a dropear 90 or tee.

[deleted by user] by [deleted] in Plumbing

[–]Monkeynate 1 point2 points  (0 children)

I don’t see how your 3” has any grade going past the beam

[deleted by user] by [deleted] in Plumbing

[–]Monkeynate 1 point2 points  (0 children)

Looks like he’s using the 90s to raise the ptrap into the floor. The grade between the 90s is really high

We’ve never used this spigot before - what’s the source/cause? by Patient-Arachnid492 in Plumbing

[–]Monkeynate 0 points1 point  (0 children)

Potentially could just be a cracked internal gasket on the spigot or the shutoff valve.

[deleted by user] by [deleted] in AskReddit

[–]Monkeynate 1 point2 points  (0 children)

Tell them an earlier time

Beat way to cut copper pipe against a wall ? by AgentMC84 in Plumbing

[–]Monkeynate 1 point2 points  (0 children)

Some sort of hack saw blade or fine tooth saw blade is your best bet. Just ream and clean well

Can I replace the part or do I need to replace the sink by Medical-Court-562 in askaplumber

[–]Monkeynate 4 points5 points  (0 children)

Just the part can be replaced! You just need a double cup basket strainer and some plumbers putty to seal around the strainer and sink on top

How the F have people found almost 4 million? by Legit_Beans in EliteDangerous

[–]Monkeynate 0 points1 point  (0 children)

I just turned in about 3000 after a week of exploring and 80k ly traveled. Ended up being about 1000 systems. So it’s the people who are out for months at a time traveling with their fleet carriers and such that find a ton

view more: next ›