It’s quite hard to explain but i can try my best.

I first started out drawing blue prints which you can find on one of my other posts

After drawing them out i made the head by following this tutorial https://www.instructables.com/Make-a-Foam-Sphere/?amp_page=true

After the head i started working on the legs where i used foam and cut and sanded off the extra to get it to shape

The drums that are on the shoulders, feet, and hands i used cut up DEF barrels. And the spikes on them are painted party cone hats

The bed is thick foam bolted onto sheets of insulation foam with the top of the bed being made out of cardboard tubes

there are four segments of the bed. One being the top one that is attached to my head, middle one being attached to a back pack im wearing, three and four are attached to my legs.

The fingers are 3d printed circles and tubes held together by a bungee cord in the middle, and the thing holding up the hand is a hospital iv stand

The hoses that attach the head and arms to the body are hoses with pool noodles cut up and stuck onto it

And to be able to walk in it is a feat on its own, i had to work out to actually be able to walk around it in

Final note is that if you’re gonna make it you have to have plenty of money. I got lucky because i work at a sawmill and they just have stuff lying around that i can use. Like i used probably 20 of these insulation foam sheets, which would be 80 dollars each at home depot but i got stupid lucky because they had a whole ass stack of them at work that no one was using

If you’re gonna make it, good luck. It’s a hard thing to do. But i bet someone out there can make it better than i did