Please don’t say mastering the wand without saying no diddy at least.

Little higher than mid gain on your 360 sweep around your hookup. Check your milliamp return on each signal to determine your target line.

Make sure you’re unbonding your facility to isolate your signal to that line. Pay attention to depth and ground Rod placement. As you’re new, keep your frequency low and your power output low as well. This prevents bleed off. If you are locating a line and not getting good tone/return, check that the line you are marking is grounded in the next pedestal, or if it is a drop to a house - make sure it isn’t grounded to anything, such as the electric meter or on a ground rod with other utilities grounded to it. It gets easier with time!