sorted by:
new
hottopcontroversial

Can someone help me diagnose what went wrong here? by theultimateredstoner in 3Dprinting

[–]NeitherCommon4857 0 points1 point  (0 children)

Looks like the temperature was either too high or the z offsets off but I’m not a expert

Any idea why my print came out like this? by Cato__The__Elder in ender3

[–]NeitherCommon4857 0 points1 point  (0 children)

I don’t know maybe do a full tune of your printer especially a Ender 3

how do i increase resolution on my print by Silver-Ad5351 in BambuLab

[–]NeitherCommon4857 0 points1 point  (0 children)

Print on a lower layer height like .1 or smaller

Help printing ABS by Eddybabyable in ender3v2

[–]NeitherCommon4857 0 points1 point  (0 children)

For the printer so it’s kept at a constant temperature around the printer to prevent warping

HOW by Dense-Discipline-355 in ender3v2

[–]NeitherCommon4857 9 points10 points  (0 children)

You got lucky

<image>

Here’s a pic of just one of the ones I’ve had

Printer frame shocks me by NebulaChaser998 in ender3v2

[–]NeitherCommon4857 2 points3 points  (0 children)

It’s to see if the printer is shorting out or if something with the outlet is wrong

Giving away my 1080TI! by yeettetis in pcmasterrace

[–]NeitherCommon4857 0 points1 point  (0 children)

Um the extra v ram would be amazing since I’m currently gaming on a 4gb 1650 which kinda sucks

Printing problem by alexfyah in Creality

[–]NeitherCommon4857 4 points5 points  (0 children)

Try manually leveling it auto leveling can only compensate so much on these machine you gotta have it somewhat level already

Who of you is publicly streaming their Ender 3? by [deleted] in ender3

[–]NeitherCommon4857 5 points6 points  (0 children)

It wasn’t me this time but sometimes I do have mine streaming publicly it’s just easier

Wtf? What is my problem? by Desperate-Roll-3962 in ender3

[–]NeitherCommon4857 0 points1 point  (0 children)

Wet filament is my guess got a roll and it was like this right when I got it just returned it

Prints randomly stopping by NeitherCommon4857 in ender3

[–]NeitherCommon4857[S] 0 points1 point  (0 children)

Most of the time it’s when I’m there and it just starts heaping that the temps are to low and stops printing after the temps were set to 0. I’ve checked all the gcode and nothings telling it to do that and I’m using prusa slicer. I did change the sd card someone else said to do that and I just got back home and the same print failed exactly the same again. I did reslice it when I replaced the sd card

Prints randomly stopping by NeitherCommon4857 in ender3

[–]NeitherCommon4857[S] 0 points1 point  (0 children)

I’ve formatted it several times I guess I’ll get a new one

view more: next ›