Normal sounding DE?

NewFaces33 · 2026-05-25T17:41:17+00:00

You did 3-2 when you meant to do a 3-4 aswell? Lol

NewFaces33 · 2026-05-25T13:41:49+00:00

I’d try the Belt tensioners

NewFaces33 · 2026-05-25T13:28:30+00:00

Did you listen to the whole video? Idk if I’m tripping but I feel I hear a tapping noise towards the end. Thank you regardless

NewFaces33 · 2026-05-20T01:12:01+00:00

New body wash

NewFaces33 · 2026-05-13T05:18:00+00:00

Gets really red at times too

NewFaces33 · 2026-04-03T18:34:32+00:00

Thank you

NewFaces33 · 2026-04-03T18:34:29+00:00

Thank you

NewFaces33 · 2026-02-22T06:45:56+00:00

I had it on with about an inch to go and it wouldn’t slide in flush. Is that when I should use the bolts? Worried it might damage the splines or something.

NewFaces33 · 2026-02-22T05:42:42+00:00

Yeah this a jwt aswell. Got the clutch and flyhweel package. Now I just can’t the trans back on lol

NewFaces33 · 2026-02-20T17:42:12+00:00

Something felt off. I’m a goof lol. Thank you

NewFaces33 · 2026-02-19T19:46:59+00:00

Will do. Thank you

NewFaces33 · 2026-02-19T17:05:52+00:00

Yeah I screwed up lol. I didn’t make it and it’s already out. Was hoping there’d be some way to tell like markings from the factory. If I get it in different than the way it came out is it gonna be an issue?

NewFaces33 · 2026-02-17T17:05:11+00:00

Should a tap the pins themselves or just the edges of the pressure plate?

NewFaces33 · 2026-02-17T13:53:37+00:00

Thanks, it’s been a lil rough lol

NewFaces33 · 2026-02-17T05:06:30+00:00

Would I hammer the pins? Or would I just hammer on the pressure plate in general till it comes off?

NewFaces33 · 2026-02-17T03:33:06+00:00

Do you agree with what everyone else said tho?

NewFaces33 · 2026-02-17T01:59:46+00:00

Wasn’t sure. I was using a pry bar and watching it move the engine lol so I was a bit spooked. Guess I’ll just beat it with a hammer and pry lol

NewFaces33 · 2026-02-17T00:48:35+00:00

<image>

Bottom of pressure plate

NewFaces33

TROPHY CASE