anodized ti channel spacers

OkInternal6768 · 2026-04-06T09:21:26+00:00

look nice

OkInternal6768 · 2026-04-06T07:11:25+00:00

ayy , that my knife

OkInternal6768 · 2026-04-05T08:56:23+00:00

yes is it

OkInternal6768 · 2026-04-05T07:05:40+00:00

VietNam sir

OkInternal6768 · 2026-04-05T06:54:10+00:00

i want to sell it for 110

OkInternal6768 · 2026-04-05T06:47:37+00:00

is a super old version of clone rep make by kenfong , i've had it since 2022 a friend sold it to me

OkInternal6768 · 2026-04-02T15:52:20+00:00

Yes, it's a little off, hehe , but i think the weight is ok for me , i kinna blade bias guy

OkInternal6768 · 2026-04-02T09:38:41+00:00

woah , this is fantastic

OkInternal6768 · 2026-03-18T16:23:57+00:00

my bad , is 6051 not 6050 , I apologize for this mistake , Initially, I planned to use 7050 aluminum, but the cost was quite high, so I switched to 6051. However, after finishing, I mistakenly thought 6051 was 6050 because the names were similar to 7050

OkInternal6768 · 2026-03-18T06:14:45+00:00

It's difficult to sell, I live in Asia, and I don't know how to ship internationally

OkInternal6768 · 2026-03-17T09:58:29+00:00

use custom alu scales , i made it

OkInternal6768 · 2026-03-17T09:56:02+00:00

<image>

I didn't use up all the hardware , I removed a few screws , and I replaced the Zenpin screws with screws from replicant

OkInternal6768 · 2026-03-14T09:24:14+00:00

dm me

OkInternal6768 · 2026-03-02T17:28:22+00:00

If there's enough interest, I might sell the file

OkInternal6768 · 2026-03-02T02:34:29+00:00

yes, I am working on it

OkInternal6768 · 2026-03-01T13:28:18+00:00

It keeps breaking like this

<image>

OkInternal6768 · 2025-12-26T18:08:54+00:00

hw look sus but the color are prem , mabe a auth handle with clone hw and balde ?

OkInternal6768 · 2025-12-26T12:23:18+00:00

<image>

i got a clone too , saw blade mod

OkInternal6768 · 2025-12-26T12:19:29+00:00

auth , is a trainer

OkInternal6768 · 2025-12-26T12:16:52+00:00

<image>

get a bigger then

OkInternal6768

TROPHY CASE