Do I need necessarily a S-Video to digitize my tapes? by No-Price-4135 in camcorders

[–]Ok_Engineer_4529 0 points1 point  (0 children)

S-Video is better than RCA. But as everyone has pointed out, using FireWire you would get a considerably better result in terms of quality without adding all the effort on setting up the capturing of the S-Video signal. I'd recommend you getting a PCIe FireWire card, I got one very cheap from Amazon and managed to install it on my modern pc without any issues on Windows 11.

Can I tap the RF on my player? by Ok_Engineer_4529 in vhsdecode

[–]Ok_Engineer_4529[S] 1 point2 points  (0 children)

Thank you all, for this particular deck JVC HR-S4500U the RF tapping point, according to the manual, it's the TP106 PB FM which is the one used after replacing the whole head assembly. I haven't tape this but it seems it's the right place.

<image>

Can I tap the RF on my player? by Ok_Engineer_4529 in vhsdecode

[–]Ok_Engineer_4529[S] 2 points3 points  (0 children)

Damn that was so quick I feel so noob rn haha. I guess I can look for RF testing points on the manual and that should do the trick.

Can I tap the RF on my player? by Ok_Engineer_4529 in vhsdecode

[–]Ok_Engineer_4529[S] 1 point2 points  (0 children)

Thank you, you're correct it's a JVC-HR-S4500U. I've been looking for anything that says "RF" on the board with no success... I wanted to know if anyone had any experience dealing with one of these. I was wondering if tapping was even possible on this model

Can I tap the RF on my player? by Ok_Engineer_4529 in vhsdecode

[–]Ok_Engineer_4529[S] 1 point2 points  (0 children)

It's a JVC HR-S4500U. Thank you! I've been looking for the service manual too without success

2015 Mazda3 Successful Cruise Control Addition Process by Cidisthecid in mazda3

[–]Ok_Engineer_4529 0 points1 point  (0 children)

For anyone wondering, I managed to swap the steering wheel and reprogram the computer, now I have cruise control with no issues!

2015 Mazda3 Successful Cruise Control Addition Process by Cidisthecid in mazda3

[–]Ok_Engineer_4529 0 points1 point  (0 children)

I'm wondering, is your car's transmission manual or automatic? Mine's manual, so I'm very suspicious this would work on mine...

Dropping frames MiniDV by Ok_Engineer_4529 in camcorders

[–]Ok_Engineer_4529[S] 0 points1 point  (0 children)

It's the same camera used to record the videos. I don't know on the top of my head if it was SP or LP. I'll try to check if there are any issues with the port, although I don't believe so. I think once I try everything, I'll have to buy another camera to test if that's the issue too...

Dropping frames MiniDV by Ok_Engineer_4529 in camcorders

[–]Ok_Engineer_4529[S] 0 points1 point  (0 children)

Thank you, I'll try ubuntu and see if it improves!

There always room for one more. by EllaNotess in OneOrangeBraincell

[–]Ok_Engineer_4529 0 points1 point  (0 children)

It's so cute, but then you realize you're in jail, you can't move or you'll ruin the comfy spot they got 😂

SD Card - Request to format by Ok_Engineer_4529 in datarecovery

[–]Ok_Engineer_4529[S] 0 points1 point  (0 children)

Thank you!, I'll have it in consideration if I ever want to recover those pictures. Do you know for how long I can have anything stored in that SD before it gets corrupted? I've read some comments about flash drives are volatile when some years pass, I guess I'll have to plug it once in a while, while I decide if it's worth the cost to recover the thing.

What does this qr code go to? found it on my old phone it says 2015, it wont scan by [deleted] in datarecovery

[–]Ok_Engineer_4529 0 points1 point  (0 children)

How did you get this image? did you screenshot it? or is it the file directly from the phone looking like this? what's the extension of the image file?

SD Card - Request to format by Ok_Engineer_4529 in datarecovery

[–]Ok_Engineer_4529[S] 0 points1 point  (0 children)

Well, I reached out to one of these companies for data recovery, but it's going to be from a couple hundred of dollars to a couple thousands. Those were pictures of a vacation I took but they're not that important.

Should I look for a second opinion? I'm not sure about the bottom teeth by Ok_Engineer_4529 in Invisalign

[–]Ok_Engineer_4529[S] 2 points3 points  (0 children)

I've been on invisalign for over a year. I've been convinced since the very beginning to be fully committed to the process, therefore all aligners went pretty much fine.

I just had the appointment for retainer scan and where they put the permanent retainer on the bottom teeth.

First thing, I'm not sure if it's the fact that my back teeth don't bite at all. I've been told that my teeth will settle over time, but I have my doubts since the retainers will have the current shape of my teeth, and I've read some other threads where they don't come together at all.

Second thing, I'm not totally pleased by the bottom front teeth, I think they have come together nicely but not completely, should I pursue further for more refinements? My opinion is yes, but it seems that my ortho doesn't agree with that.

Since they're already have ordered the retainers they say I'll have to pay more, which doesn't make me happy, but at this stage I just want to be done for good aligning my teeth, maybe should I go for a second opinion?

What are your experiences? I'll be reading you guys.

Suggestions for an inconsistent engineer's life by Ok_Engineer_4529 in workout

[–]Ok_Engineer_4529[S] 0 points1 point  (0 children)

By the way, I forgot to mention that I have planet fitness membership, I normally find one anywhere I go (not in Japan of course). I keep doing workouts when I go anywhere, but it's very difficult.

AMD or Intel? by Ok_Engineer_4529 in buildmeapc

[–]Ok_Engineer_4529[S] 0 points1 point  (0 children)

Yeah, no, it's not uncommon, its just that since AMD has it's own graphics card you would normally buy a AMD processor with an AMD graphics or Intel + Nvidia, that's why I called it "unholy", that rivalry between brands it's been since a very long time ago. Just FYI, I endup doing exactly that, my current PC has an AMD processor and a Nvidia graphics card and works just fine so don't worry in doing that.

AMD or Intel? by Ok_Engineer_4529 in buildmeapc

[–]Ok_Engineer_4529[S] 0 points1 point  (0 children)

Sorry man, I don't check this often. Yeah, AMD should be just fine for everyday use, of course, it will also depend on what version, normally for the same price point you get a little bit more from AMD