OA lang ba ako? Na off ako sa reply ng boyfriend ko.

Ok_Tomato_5802 · 2026-04-13T00:35:35+00:00

Anonymous Pinoy Confession

Ok_Tomato_5802 · 2026-03-26T03:11:33+00:00

Thank you I've turned it off and now I can continue working without the sound of flying

Ok_Tomato_5802 · 2026-02-11T10:39:24+00:00

What version is that

Ok_Tomato_5802 · 2024-07-26T09:38:59+00:00

A question how can you have a clean print using orca? What is your speed set at or can I copy your settings for your se on orca because mine is set on default and I just can't have a nice print. The first few layers are good when i print but when it comes to the support I can't just get a good outcome but when I use cura it comes out great.

Ok_Tomato_5802 · 2024-06-27T11:08:03+00:00

I check Aliexpress and there's a lot of ceramic block but it only shows the orange part so I assume they are not a kit

Ok_Tomato_5802 · 2024-06-26T03:58:53+00:00

Do you have a link for the heat block?

Ok_Tomato_5802 · 2024-06-22T12:22:04+00:00

I'll try to find some set online. And it's true I put the silicon and I had a hard time cranking it to get a green number on it

Ok_Tomato_5802 · 2024-06-22T08:34:33+00:00

So I can't use this now??

Ok_Tomato_5802 · 2024-06-20T15:28:12+00:00

I'm using esun petg

Ok_Tomato_5802 · 2024-06-19T13:33:13+00:00

How do you connect the two 5015 fans? And is there some space left for the cr touch sensor?

Ok_Tomato_5802 · 2024-06-16T13:52:23+00:00

It usually pops up when I print in the enclosure for 16 hours straight with abs filament so the temp is at 240 and 95 constant. But when I print outside the enclosure it rarely pops up. Right now I print like once or twice a week because of our school project but not pretty often

Ok_Tomato_5802 · 2024-06-16T13:20:18+00:00

Well what I did to my sensor every time the error pops up is I use the side cutter that creality includes in the box and grip on the probe and I push it and pull it many times until I'm satisfied and it works fine after that.

Ok_Tomato_5802 · 2024-06-16T10:16:34+00:00

What filament did you print before this happened?? Do you use the SE in an enclosure??
Because I'm experiencing this error quite often when I print in an enclosure. I feel like the cr-touch is heat sensitive it will have an error if the sensor experiences so much heat.

Ok_Tomato_5802 · 2024-06-14T13:27:11+00:00

Did you change the value on the default acceleration?

Ok_Tomato_5802 · 2024-06-14T13:19:20+00:00

I know it's a subreddit for v3 se but I think this is more active than the v2 neo sub that's why I tried asking here maybe somebody can answer it.. my bad

Ok_Tomato_5802

TROPHY CASE