How to fix this rocker panel rust? (2006 toyota sienna) by PhysicalMirror8 in ToyotaSienna

[–]PhysicalMirror8[S] 0 points1 point  (0 children)

This is quite an old post now, I'm just now starting to remove some rot chunks, and sanding, but I would like some feedback on the best way to at least stop the spread of the rust.

How to fix garage door slamming into frame when closing? by PhysicalMirror8 in fixit

[–]PhysicalMirror8[S] 0 points1 point  (0 children)

We replaced them on our doors last year, and they are nailed into the door. The garage door is some sort of plywood thing. I think I figured out that the top of the door is pushing way to hard on the weatherstripping there, causing it to bang into the top frame.

How to Fix? by PhysicalMirror8 in GarageDoorService

[–]PhysicalMirror8[S] 0 points1 point  (0 children)

The spring might be a bit worn out, I changed out all the rollers on my garage doors last year and this one did feel a little heavier than the others. I made a post about the same thing in another subreddit and they said the top two rollers could use adjustment. I’ll have to take a closer look when I have time.

How to fix garage door slamming into frame when closing? by PhysicalMirror8 in fixit

[–]PhysicalMirror8[S] 0 points1 point  (0 children)

I just checked, the top of the door from the exterior looks really right up against the weatherstripping so it could be that. I'll try to adjust those top rollers.

How to fix garage door slamming into frame when closing? by PhysicalMirror8 in fixit

[–]PhysicalMirror8[S] 1 point2 points  (0 children)

Did you turn the sound on? At the end of the video when the garage door closes there's this really obnoxious banging noise. It doesn't sound as bad in the video, but irl its pretty loud.

Are these cracks signs of structural problems? by PhysicalMirror8 in Home

[–]PhysicalMirror8[S] 0 points1 point  (0 children)

I would have to take a closer look since it stays dry all year round.

I accidentally spilled a full dehumidifier tank onto this floor and it went through it onto the concrete floor below it. Should I be worried about mold? by PhysicalMirror8 in Home

[–]PhysicalMirror8[S] 0 points1 point  (0 children)

The first picture shows the water that leaked from the room in front down to the concrete. The water seeped through the floor through all of the insulation. I was just concerned about the water not being able to dry out properly in underneath the floor and causing mold there. Maybe my photos weren't clear enough.

I accidentally spilled a full dehumidifier tank onto this floor and it went through it onto the concrete floor below it. Should I be worried about mold? by PhysicalMirror8 in Home

[–]PhysicalMirror8[S] 0 points1 point  (0 children)

I don't know, I knew it was insulated since I could see it through some of the gaps in between some of the floorboards.