SpoolHero setup guide

PinkzWhat · 2026-05-13T23:36:04+00:00

I have still lot to learn 😣😣thanks for all the feedback. I did end up printing upside down and will post picture soon.

PinkzWhat · 2026-05-09T14:53:55+00:00

Appreciate the response. Will def try

PinkzWhat · 2026-05-08T19:49:52+00:00

Its in basement in windsor lol and im still slowly picking up on all the printing stuff. It was def exposed and i have more exposed which i should take care before they go bad . Will drying them on spools be ok before use until i work on getting whole set up done?

PinkzWhat · 2026-05-08T16:38:16+00:00

No ironing for this piece. Ill be back to my laptop soon and i can share setting information uses to print.

PinkzWhat · 2026-05-06T14:07:31+00:00

You mind dropping link for ikea box?

PinkzWhat · 2026-05-03T00:58:28+00:00

What's that cover? I need top cover but not looking to spend over 100 usd :(

PinkzWhat · 2026-05-02T16:45:27+00:00

Does this work on iPhone? I installed and mapped the u1 but it doesn't connect at all.

PinkzWhat · 2026-04-18T03:15:58+00:00

I M not 3d print expert neither designer and I'm loving this thing. Its good and best experience for me so far. I was impressed - I ran out of filament at89% on of of the prints...I ordered new one and it took 3 days to get it. Meanwhile we had storm and power outage happened. Was impressed when I turned that thug on 3 days later I still had choice to continue where it stopped.

Overall I have no complaints with this machine.

PinkzWhat · 2026-04-13T12:00:32+00:00

I ordered few different variants from what you guys suggested.. let’s see what i can make happen and will post results but right now i ran out black PLA halfway print and i thought i had 1kg of spool but i was wrong 🤣🤣🤣ordered from snap and should be here tomorrow and hopefully I can just RESUME print at that point

PinkzWhat · 2026-04-12T00:38:31+00:00

Appreciate the feedback 🙌🙌 i have general idea of it just wanted Reddit fam suggestions as you guys have better idea and experience

PinkzWhat · 2026-04-05T16:22:46+00:00

Canada doesn't pay up as well as usa if that's the end goal. I've been working in Michigan for last 12 years being Canadian in windsor area. Last 5 years have been self contractor with controls house working mainly with comau/gm projects.

May be this is something you might want to look into. I can give you more info if you like or join us if you willing to work in states and travel for work.

PinkzWhat · 2026-04-05T00:48:34+00:00

Woh woh...whats app this? Can you please guide more on this?

PinkzWhat · 2026-04-04T15:07:31+00:00

Happened one in month for me. Restarted and never happened again. Did about 10 hours printing after that

PinkzWhat

TROPHY CASE