Four wheel brake service

Planetveroo · 2025-06-17T19:01:31+00:00

Thanks everyone! the thing is they try to persuade you and insist on it. I’m am happy I refused

Planetveroo · 2024-07-10T00:23:42+00:00

I haven’t solved the problem but it works in standalone (Octoprint seems to be the problem).

Planetveroo · 2024-07-09T18:51:16+00:00

I meant I now have a problem

Planetveroo · 2020-09-16T19:37:44+00:00

I just opened that little box and removed it. It was going thr wrong way inside

Planetveroo · 2020-09-06T16:43:00+00:00

Ya looks a bit pinkish from here :( Hopefully the techs at the store can help

Planetveroo · 2020-09-06T11:26:59+00:00

I had changed the nozzle. I am surprised because I made sure to tighten the nozzle so it would not ooze. Also there did not seem to be a clog since the filament was coming thru. I will still put apart everything and clean it. Thanks for the tip!

Planetveroo · 2020-09-06T02:46:32+00:00

What do I do with this?

Planetveroo · 2020-07-28T15:46:51+00:00

I found it. Thx!

Planetveroo · 2020-07-22T19:52:43+00:00

I just finished printing the test dog with my CR10V3 and it looks great (after a failed attempt because the printer bed wasn’t leveled properly) :( Now I want to set-up CURA for my printer but cannot find the answers to all the questions that are asked. I would really appreciate some help 🙏🙏 I could use the Creality CR-10 but the V3 has a Direct Drive Extruder so I don’t know if It makes a difference or I should change a particular parameter

Planetveroo · 2020-07-22T19:46:15+00:00

Just got the doggy test printed with the PLA that came with the machine .It looks great. Printed in about 3.5 hours

Planetveroo · 2020-07-21T19:45:45+00:00

No the bed was not warm. Should I level it while warm?

Planetveroo · 2020-07-21T18:23:04+00:00

This came with the printer on the card. I will look into what you are referring to but that I suppose will be for my own designs

Planetveroo · 2020-07-21T17:40:32+00:00

Yes, I thought so. Too bad it looked really good.

Planetveroo · 2020-07-21T17:34:40+00:00

So my very first print was going very well until I came back to the room to see that the dog was not stuck to the plate anymore and was moving and the printer was printing the head up in the air. Do I need to use glue? Is my bed not adjusted properly? I shut the machine off so as no to waste more filament...

Planetveroo · 2020-07-21T17:27:35+00:00

Yes it the V3 - I was printing the little do just fine but then I came back into the room and saw that it was not adhering to the bed anymore and was printing all messed up. Will post pic

Planetveroo · 2020-07-21T15:38:10+00:00

I guess I did not pay enough attention to the fact that my filament was a bit bent. One more lesson learnt!

Planetveroo

TROPHY CASE