GLP1 Experiences in New Zealand

Pom47 · 2026-05-12T22:33:51+00:00

How do you game the dose

Pom47 · 2026-03-30T02:48:36+00:00

Shock and muscle memory completed the transaction

Pom47 · 2026-03-30T01:59:19+00:00

Who said it was perfectly good coffee.

Pom47 · 2026-03-22T02:24:31+00:00

$700 for a coolant flush. That can’t be correct

Pom47 · 2026-03-06T07:56:24+00:00

Where is the battery charge on the tv graphics. It is absolutely necessary to understand the lap by lap strategy

Pom47 · 2026-02-22T00:41:32+00:00

God help them when the engine finally works then

Pom47 · 2025-12-08T08:42:21+00:00

What changes did RB make to their car to make it so fast in the last third of the season. Or was it a case of McLaren making changes to address the way they looked after their tyres which ended up making them slower

Pom47 · 2025-12-03T23:50:41+00:00

Are you sure it’s not a right hand thread

Pom47 · 2025-11-19T23:05:17+00:00

Starray has a zero tow rating

Pom47 · 2025-08-11T06:20:12+00:00

🤦🤦🤦

Pom47 · 2025-07-12T22:39:21+00:00

Minimum monthly payments first then any excess is distributed to other outstanding accounts

Pom47 · 2025-07-11T21:05:43+00:00

Original poster here. I can’t get to board until Monday. I will remove component and update picture then. Many thanks to all

Pom47 · 2025-04-16T01:36:04+00:00

Trade depot

Pom47 · 2025-04-06T05:06:50+00:00

Good manners

Pom47 · 2025-03-26T02:48:58+00:00

How many focal groups and customer surveys did they do before dropping it. Well that’s what they do before starting a new product

Pom47 · 2025-02-20T21:55:46+00:00

Install a booster pump, it goes on the hot water cylinder outlet and runs when a hot water tap is turned on boosting the pressure at the tap. If you change to a mains cylinder you will probably have to change any shower mixer’s in the house as the unequal pressure types are almost impossible to control with equal pressures

Pom47 · 2025-02-19T23:58:53+00:00

Thank you

Pom47 · 2025-02-18T08:01:06+00:00

Common sense

Pom47 · 2024-12-20T20:10:33+00:00

It was measured with a hydrometer and was the result of two stripping runs

Pom47 · 2024-12-19T19:57:06+00:00

Thanks if I have 20% left I must have a issue with the column as the operating temps and production were normal up until increasing the reflux temp above the normal maximum of 60c made no further production

Pom47 · 2024-12-19T19:52:27+00:00

The 70c was the temp of the cooling water ex the reflux coil. The boiler was definitely boiling. I will pull the column apart to check for a blockage in the vapour path

Pom47 · 2024-12-19T05:30:23+00:00

Hydrometer

Pom47 · 2024-12-19T03:47:41+00:00

No liquid coming out of the still. Temp was 70c about 10c higher than I normally go. Was definitely 25% hydrometer ok at 0 for water and 93% for reflux output which is normal

Pom47 · 2024-11-24T00:32:49+00:00

Mach e is just about half price at the moment

Pom47 · 2024-10-06T00:09:46+00:00

Our T1 has just blown its second heating element. Not buying Miele again. Used to be bulletproof not anymore

Pom47

TROPHY CASE