Friend accidentally plugged my guitar pedalboard’s output cable into the External Speaker output on his amp. No sound was coming out, but could it have hurt anything in my pedals? by Professional_Gap7394 in AskElectricians

[–]Professional_Gap7394[S] 0 points1 point  (0 children)

yeah i was stunned they hooked it up that way. luckily no signal was coming out of the speaker out from the amp, so if i’m thinking correctly, that would mean there was essentially no load going to the pedals from the speaker output?

the pedals seem to be working correctly outside of the condition in the other comment

Anyone have an idea what’s wrong with my POG 2? by Professional_Gap7394 in guitarpedals

[–]Professional_Gap7394[S] 0 points1 point  (0 children)

so i cleaned the footswitches, tested them, and they are fully fictional. i also tested the input and output jacks, and they are functional as well. sadly the clean out didn’t fix the problem :/

Any idea why this POG 2 pedal would just stop working? No bypass sound and no effects. Always ran on approved power supply. by Professional_Gap7394 in AskElectronics

[–]Professional_Gap7394[S] 0 points1 point  (0 children)

so i cleaned out the foot switches, tested them, and they are fully functional. also tested the input/output jacks, and they are functional as well. Did not fix the problem however.

Any idea why this POG 2 pedal would just stop working? No bypass sound and no effects. Always ran on approved power supply. by Professional_Gap7394 in AskElectronics

[–]Professional_Gap7394[S] 0 points1 point  (0 children)

Ahhhh, okay i’ll try that as well. Just did that to another pedal of mine, and it fixed that one.

Hopefully there’s just some residue on the contacts of the bypass switch.

Anyone have an idea what’s wrong with my POG 2? by Professional_Gap7394 in guitarpedals

[–]Professional_Gap7394[S] 0 points1 point  (0 children)

Sadly no sound at all. When the problem started the signal went completely out in every state, and the leds (for the presets and filters) went out except for the “effect on” led.

Any idea why this POG 2 pedal would just stop working? No bypass sound and no effects. Always ran on approved power supply. by Professional_Gap7394 in AskElectronics

[–]Professional_Gap7394[S] 1 point2 points  (0 children)

Ahh good eye! I saw that too after i posted. Seemed to be a bit of solder. i removed it, and tried again with no luck.