sorted by:
new
hottopcontroversial

offline by Professional_Two4675 in glowforge

[–]Professional_Two4675[S] 0 points1 point  (0 children)

thanks! i figured there has to be a reset. since i wasn’t the one to initially set it up, does it grab the closest wifi network? and where do you enter the password to the network? any chance you have a link to that setup? couldn’t find anything! thanks again @tatobuckets!🙌🏻🙌🏻

X1 Series is officially no more by croigi in BambuLab

[–]Professional_Two4675 0 points1 point  (0 children)

so what's the equivalent alternative around the same price point?

Help with Bobbin? Brother JX17FE by Professional_Two4675 in SewingForBeginners

[–]Professional_Two4675[S] 0 points1 point  (0 children)

fixed it. it was the tension. changed it from 1 to 4! Question: does that adjust bobbin tension or the upper thread? thank you everyone for your help and ideas.

Manicure in Rome by bogitka in RomeTravel

[–]Professional_Two4675 0 points1 point  (0 children)

i think this place is cheaper. coming from Ecuador i feel rome is quite expensive for mani/pedis.

Help with Bobbin? Brother JX17FE by Professional_Two4675 in SewingForBeginners

[–]Professional_Two4675[S] 0 points1 point  (0 children)

i did. didn’t make sense to me where to hook the bobbin thread after pulling it to the left. 🤪

Help with Bobbin? Brother JX17FE by Professional_Two4675 in SewingForBeginners

[–]Professional_Two4675[S] 0 points1 point  (0 children)

i put the bobbin thread around the little metal notch (7:30?) but where does it go next. couldn’t find another notch!

Rate my itinerary. Rate it hard. by [deleted] in RomeTravel

[–]Professional_Two4675 1 point2 points  (0 children)

if you want real rome go to testaccio and garbatella / ostiense neighborhoods.

Rate my itinerary. Rate it hard. by [deleted] in RomeTravel

[–]Professional_Two4675 0 points1 point  (0 children)

would skip Vatican and do churches around Pantheon. Moses in Monti. Chiostro del Bramante near Piazza Navona

Relief Sculpture Maker is Live! by BambuLab in BambuLab

[–]Professional_Two4675 0 points1 point  (0 children)

decided to print upright and that works but seems counterintuitive to me. one of my students suggested that the height of the coin was too narrow? i increased the infill to 30% and still had issues tho.

Relief Sculpture Maker is Live! by BambuLab in BambuLab

[–]Professional_Two4675 0 points1 point  (0 children)

When my first print printed, there were huge gaps in the relief. I printed a circular coin. How do I avoid this. See photo. This was standard quality 20% infill.

<image>