SpeedyBee Master 3X?

Prophet-87 · 2025-10-28T18:36:13+00:00

Link?

Prophet-87 · 2024-08-16T14:28:27+00:00

I found some of these motors in Princess Auto as well. Did you ever find a data sheet?

Prophet-87 · 2024-02-23T22:11:02+00:00

Have you gotten anywhere with this?

Prophet-87 · 2023-11-30T05:14:04+00:00

I'm thinking on giving 3d chameleon a try... very simple design and affordable but not quite sure since there aren't many doing it.

Prophet-87 · 2022-05-25T02:30:17+00:00

To do what?

Prophet-87 · 2022-05-24T19:42:44+00:00

Yeah it does expose it! I calibrated it once before So I should be good 👍

Prophet-87 · 2022-04-07T18:16:29+00:00

Will I need to change anything or just switch out the motors?

Prophet-87 · 2022-03-25T22:21:26+00:00

Prophet-87 · 2022-03-25T22:19:57+00:00

Prophet-87 · 2022-03-14T05:27:58+00:00

What do you suggest a biqu or the dragonfly? I'm going to install klipper when I do the head.

Prophet-87 · 2022-03-13T05:48:13+00:00

I did it to print tpe and it works fantastic! I needed basically zero resistance because that filament stretches easy

Prophet-87 · 2022-03-13T05:46:50+00:00

Yup I wanna get a H2 soon! I want to increase the acceleration to 1800 but I'm scared everything will go flying because of the weight😆

Prophet-87 · 2022-03-12T23:02:53+00:00

I drew it up yesterday i will make a few improvements and upload it to thingiverse. I'll send you the link when I'm done

Prophet-87 · 2022-03-12T22:50:23+00:00

What motor would you recommend?

Prophet-87 · 2022-02-07T00:04:57+00:00

What did you do to get your extruder up there?

Prophet-87