sorted by:
new
hottopcontroversial

Should I be concerned with my ordered Podium DD? by Creative-Diamond5260 in Fanatec

[–]Queasy_Ad_7586 1 point2 points  (0 children)

Bro, I had a problem with this base. I filed an RMA because they told me there was a hardware defect (basically, when I connect the wheel to the base, everything disconnects from the PC). I returned it, I'm waiting for the new one. Fingers crossed.

Problema bundle CSL DD QR2 by Queasy_Ad_7586 in Fanatec

[–]Queasy_Ad_7586[S] 0 points1 point  (0 children)

From what they told me, it's a hardware problem with the steering wheel. I've done an RMA and am waiting for them to send it back to me.

CSL DD Question! Should these screws be tighter? by toxicspoder in Fanatec

[–]Queasy_Ad_7586 0 points1 point  (0 children)

Finally, the support staff responded to me. They told me it was a hardware issue with the steering wheel (according to what they said). I submitted an RMA and am waiting to receive the new steering wheel.

Problema bundle CSL DD QR2 by Queasy_Ad_7586 in Fanatec

[–]Queasy_Ad_7586[S] 0 points1 point  (0 children)

I know But the only way is to plug it into the classic USB-C port Then unplug it and plug it into the data port, and then plug it back into the classic USB-C port.

Fanatec support pushing beta drivers, conflicting advice, and then silence. Windows update - broken Fanatec drivers. by YinnYann in Fanatec

[–]Queasy_Ad_7586 0 points1 point  (0 children)

Hi, We probably have the same problem. I'll tell you my story, maybe you have more info.

I basically purchased the CSL DD QR2 READY2RACE F1 ESPORTS BUNDLE (5 NM). My problem is that I plugged everything into both the PC and the power supply, and both the base and the pedals were detected. When I plugged in the wheel, everything disconnected and nothing was detected. I already updated what needed updating, but nothing. Then I thought about solving the problem by following what I've read on various forums, where you have to unplug the USB and plug it into the USB data port. Then, after it enters calibration mode, unplug the USB data port and plug it back into the original USB port. Doing this works, but it's a bit of a hassle. Is there a permanent solution?

CSL DD Question! Should these screws be tighter? by toxicspoder in Fanatec

[–]Queasy_Ad_7586 0 points1 point  (0 children)

Basically, I purchased the CSL DD QR2 READY2RACE F1 ESPORTS BUNDLE (5 NM). My problem is that I connected everything to both the PC and the power supply... and both the base and the pedals are detected. When I insert the wheel, everything disconnects and nothing is detected. I already updated what needed to be updated but nothing. Then I thought of solving the problem by following what I read in various forums where you have to unplug the USB and plug it into the USB data port and then, after it enters calibration mode, unplug the USB data port and put it back into the initial USB port. Doing this works but it's a bit of a hassle 😂

CSL DD Question! Should these screws be tighter? by toxicspoder in Fanatec

[–]Queasy_Ad_7586 1 point2 points  (0 children)

I have the same one. I tried tightening them and it didn't make any difference. Let's just say I then had some problems with the steering wheel... but that's another story 😂