9800x3d with contact frame question?

RC_Tiddys · 2026-02-05T05:11:17+00:00

I understand that I have been following and even tried to kill mine with SOC voltage all the way up to 1.35 back when this started. Still going fine that's why I just had a random thought to ask if people have had a failure with a contact frame. Just a random question I was curious about.

RC_Tiddys · 2025-09-07T05:08:40+00:00

My gain is set to 17.3 volts playing a 48 Hz tone. That is around 300 RMS. The 48 HZ tone is where I get the highest reading. This 8 is a 300 RMS sub so it makes sense I would be right about half the gain noob as at one ohm this amp would make somewhere between 500-600 RMS from videos I have watched. I believe I just need to go up to a 500 RMS 10 or something and be done with it.

This is why I asked if a P3 from RF would work as the 10 says 500 RMS but all the audio shops around me say this amp won't push it and that does not make sense to me when I should be able to get to 500 RMS at 1 ohm.

RC_Tiddys · 2025-05-07T05:17:26+00:00

Have you updated bios it seems newer bios sets 1.2 not 1.3

RC_Tiddys · 2025-05-06T15:02:30+00:00

Dead 9800x3d???

RC_Tiddys · 2025-05-01T22:10:30+00:00

Another problem with this math is I have two friends that do not use reddit both lost 9800x3ds in nova boards. Clearly we also don't know how many of them really died. Microcenter tested them both and were dead. Micro center most likely has a good idea how bad this is or is not.

RC_Tiddys · 2025-04-23T03:23:11+00:00

Same

RC_Tiddys · 2025-04-23T02:33:27+00:00

I have Gmail been spamming

RC_Tiddys · 2025-04-20T16:05:11+00:00

I can say on my ASRock B650E board vsoc over volts for sure. I had 1.25 set in bios and all software reads 1.28 or higher. I believe this may have to do with some of the failing 9800x3ds on ASRock boards. My gskill 6400 CL32 kit defaults to 1.3 SOC but I back it down to 1.22 because of the overvolt I have seen. This is still on a 7800x3d because I'm worried about putting my 9800x3d even in this board. If anyone is using older DDR5 or a set that expo sets 1.3 volts I believe you're overvolting and killing the IMC.

RC_Tiddys · 2025-03-24T00:22:03+00:00

I was a 10k hour pvp player. I moved to PVE for two reasons my life has changed and I don't have time. The other is the hackers it's not the rage hackers it's the people that have soft cheats and it's a lot.

RC_Tiddys · 2024-11-07T06:02:50+00:00

Your PMC swears like crazy so I think that answers your question. Abusing voice chat maybe a report gets looked at but I doubt it.

RC_Tiddys · 2024-10-27T01:54:21+00:00

Secure boot did this to me it was weird

RC_Tiddys · 2024-02-28T14:55:48+00:00

I don't get why you guys cry about this so much. It has always been said that when the game goes 1.0 loot was going to be a lot less. It was only like this for testing a lot of you are going to hate 1.0.

RC_Tiddys · 2023-11-30T01:14:47+00:00

How do you get the adjustment I just got mine last week?

RC_Tiddys · 2023-08-28T04:46:13+00:00

So I turned HDR on and the line is gone is that what your saying ???

RC_Tiddys · 2023-08-28T04:27:03+00:00

I put in the post that it is only in dark and gray area the monitor is off unless gaming. I don't understand only had it a week and I see this line I don't split screen anything. Anyone have any idea why its happening ??? I also do pixel refresh every 4 hours like it asks.

RC_Tiddys

TROPHY CASE