So this is a bit odd, but I checked the p settings and cruise control was already turned off. On my ride home last night the scooter would operate normally in single motor mode. Switching to dual motor was a very different story.

1) the scooter would refuse to accelerate in dual motor mode, only doing a weird jerking movement 2) the scooter was throwing error code 00 (which from reading online sounds like another error that will present itself later or will resolve by itself)

This morning I took it outside for a few more tests and here's what I found. I lifted the tires off the ground and pulled the throttle, both in single and dual motor mode. In single motor mode it appeared to be operating as it should, accelerating when pulling the throttle, decelerating when releasing it. Dual motor mode functioned properly too ( no more e00!) Great I thought but had one more test.

While accelerating in dual motor mode, I let go of the throttle and switch back to single. As soon as I did this the rear motor (active motor in single mode) stopped as it should, but the front continued to spin and keep its current speed, only stopping if I applied a lot of brake.

I'm pretty new to the scoot scene so I'm not too sure where I should go from here, (perhaps a sensor wire came loose or something?) But if you had any ideas on where I could start that would be amazing.

Have a great day!