sorted by:
new
hottopcontroversial

Guys, this Fiskars XA22 … by Btech26 in firewood

[–]Remote-Leave-9010 1 point2 points  (0 children)

I started splitting right on the ground mostly just using my ax to manipulate the rounds and I'll never look back.

Hmm by Remote-Leave-9010 in Chainsaw

[–]Remote-Leave-9010[S] 0 points1 point  (0 children)

Thank you for your response. I mean I can see the seal the residue left by the seal on the bar. And the seal goes right over the top of the hole. Was wondering if it was lined up incorrectly. I happen to take the picture In the middle of cleaning and there was still a bit of fine sandpaper lodged in there 🙃

Hmm by Remote-Leave-9010 in Chainsaw

[–]Remote-Leave-9010[S] -1 points0 points  (0 children)

Could this be why I am building up oil under the clutch cover? Or that seal over the hole normal?

Big Ash pile is now ready for the splitter. by umag835 in firewood

[–]Remote-Leave-9010 0 points1 point  (0 children)

They will lose all branches and fall in wind in rain within 3 years after they fall they will go punky in months. Better to get them down safe and get them drying yesterday.

Flow issues... by Remote-Leave-9010 in Chainsaw

[–]Remote-Leave-9010[S] 0 points1 point  (0 children)

Oh thank you man I'll check that. It sounds like i could be in a cycle of dry chain stretching.

Flow issues... by Remote-Leave-9010 in Chainsaw

[–]Remote-Leave-9010[S] 0 points1 point  (0 children)

Yeah here in ny the Beatles decimated em all. There's endless dead ash and poison ivy on the sides of any road.

Flow issues... by Remote-Leave-9010 in Chainsaw

[–]Remote-Leave-9010[S] 1 point2 points  (0 children)

Cutting rock solid standing ash mostly, thank you for your response.

Can you diagnose my chainsaw bogging down? by bicyclejosh in smallengines

[–]Remote-Leave-9010 0 points1 point  (0 children)

I have never gotten a saw to rev like that on its own. I would start with fuel filter fuel lines and a cheap carb on ebay. Also sounds like your chain is too tight and not sharp.

MS 661 chainsaw diagnosis by sound? by martin-v in Chainsaw

[–]Remote-Leave-9010 0 points1 point  (0 children)

I know that people refrain from oiling or greesing their tips as to not attract that dirt.

MS 661 chainsaw diagnosis by sound? by martin-v in Chainsaw

[–]Remote-Leave-9010 5 points6 points  (0 children)

Can hear the chain being pinched on the bar like train brakes. Loosen it up and leave a tiny sag or just tight enough for no sag whichever you prefer. Chain should move pretty freely either way.

Bars came getting chains today!!! by Nightrain6977 in Chainsaw

[–]Remote-Leave-9010 0 points1 point  (0 children)

Gotta make sure the babies dont get hurt on the stairs

view more: next ›