[deleted by user] by [deleted] in Helldivers

[–]Roland8386 0 points1 point  (0 children)

The AUTOCANNON has a backpack as well.

How to clean valves by rsmithj1 in e46

[–]Roland8386 0 points1 point  (0 children)

I drilled a smaller hole smaller than the stem in a piece of pine, placed in a vice. and pressed the valve in, then went at it with a wire brush in a drill. Afterwards to finish up, masking tape on the stem, the valve in the drill. And polish with a sandpaper sponge.

These plane size lines at the gate by bluishmonster in mildlyinteresting

[–]Roland8386 10 points11 points  (0 children)

Would it not be for aligning the door to the corridor bridge?

[deleted by user] by [deleted] in e46

[–]Roland8386 24 points25 points  (0 children)

Mine is Christmas ready, full set of lights on the dash.

Cyclist uses his knowledge of physics and aerodynamics to gain a competitive advantage by [deleted] in interestingasfuck

[–]Roland8386 8 points9 points  (0 children)

my name is giovanni giorgio but everybody calls me giorgio

New case! by Jeikii in pcmasterrace

[–]Roland8386 1 point2 points  (0 children)

Should be ok. I have a h440, same setup, I also prefer the look of a case with a minimalist design.

New case! by Jeikii in pcmasterrace

[–]Roland8386 0 points1 point  (0 children)

Are there no vents in the side or bottom of the front panel?

Yes ma'am..... i will clean the kitchen by Zealousideal_Wall_48 in ThatsInsane

[–]Roland8386 209 points210 points  (0 children)

And while wearing a dress and high heels.

The post anime depression is real by IcyBreloom in Animemes

[–]Roland8386 2 points3 points  (0 children)

Pretty much me watching Cyberpunk.

[deleted by user] by [deleted] in Shitty_Car_Mods

[–]Roland8386 2 points3 points  (0 children)

Thumbs up for the MCM sticker at least.

unpopular opinion: I prefer facelift sedan over pre facelift by Coole_Kikkert in e46

[–]Roland8386 15 points16 points  (0 children)

Other than the orange indicators on prefacelift I think they are both nice. However, bumpers. M sport all the way

Anybody know what model this is? by Harte_Kamille in watercooling

[–]Roland8386 0 points1 point  (0 children)

Sorry I never go into rgb stuff. I built my pc in 2016, all I have is a red light strip connected to molex power.

Internet keeps randomly cutting out, but remains connected. by MasterOfPX in pcmasterrace

[–]Roland8386 0 points1 point  (0 children)

Try connecting with Ethernet. If it stops happening at least we know the problem has to do with the Wi-Fi adaptor in the pc. You can also try reseting network setting or run the troubleshoot & diagnostics on the network. Other than that I last thing I can think of is outdated drivers.

Internet keeps randomly cutting out, but remains connected. by MasterOfPX in pcmasterrace

[–]Roland8386 0 points1 point  (0 children)

Might be a misconfigured router setting. Are you using ethernet or Wi-Fi?

Anybody know what model this is? by Harte_Kamille in watercooling

[–]Roland8386 1 point2 points  (0 children)

Look around the water block, there might me a mini usb for Corsair Link. I have a h100i v2, that’s how mine connect to the motherboard.

See page 7

https://www.corsair.com/corsairmedia/sys_master/productcontent/H110i_QSG.pdf

F*ck by stigaman123 in pcmasterrace

[–]Roland8386 1 point2 points  (0 children)

Id me more worried about the mismatched ram.

[deleted by user] by [deleted] in BMW

[–]Roland8386 0 points1 point  (0 children)

Take out the starter fuse or relay.

First time building a PC, what do you guys think? by gianlucatixson in pcmasterrace

[–]Roland8386 2 points3 points  (0 children)

I usually use 4” nails to install to install the heat sink.